linux/arch/arm64
Robert Marko e836070f94 arm64: dts: marvell: espressobin-ultra: add PHY and switch reset pins
Both the Topaz switch and 88E1512 PHY have their reset and interrupts
connected to the SoC.

So, define the Topaz and 88E1512 reset pins in the DTS.

Defining the interrupt pins wont work as both the 88E1512 and the
Topaz switch uses active LOW IRQ signals but the A37xx GPIO controller
only supports edge triggers.
88E1512 would require special setup anyway as its INT pin is shared with
the LED2 and you first need to configure it as INT.

Signed-off-by: Robert Marko <robert.marko@sartura.hr>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Gregory CLEMENT <gregory.clement@bootlin.com>
2022-05-09 10:56:13 +02:00
..
boot arm64: dts: marvell: espressobin-ultra: add PHY and switch reset pins 2022-05-09 10:56:13 +02:00
configs ARM: DT updates for 5.18 2022-03-23 18:37:22 -07:00
crypto crypto: arm64 - cleanup comments 2022-03-09 15:12:32 +12:00
hyperv arm64: hyperv: Initialize hypervisor on boot 2021-08-04 16:54:36 +00:00
include Char/Misc and other driver updates for 5.18-rc1 2022-03-28 12:27:35 -07:00
kernel ptrace: Cleanups for v5.18 2022-03-28 17:29:53 -07:00
kvm ARM: 2022-03-24 11:58:57 -07:00
lib Merge branch 'linus' of git://git.kernel.org/pub/scm/linux/kernel/git/herbert/crypto-2.6 2022-03-21 16:02:36 -07:00
mm kasan, arm64: don't tag executable vmalloc allocations 2022-03-24 19:06:48 -07:00
net kasan, arm64: don't tag executable vmalloc allocations 2022-03-24 19:06:48 -07:00
tools Merge branch 'for-next/spectre-bhb' into for-next/core 2022-03-14 19:08:31 +00:00
xen xen: allow pv-only hypercalls only with CONFIG_XEN_PV 2021-11-02 08:11:01 -05:00
Kbuild kbuild: use more subdir- for visiting subdirectories while cleaning 2021-10-24 13:49:46 +09:00
Kconfig Char/Misc and other driver updates for 5.18-rc1 2022-03-28 12:27:35 -07:00
Kconfig.debug arm64: remove TEXT_OFFSET randomization 2020-06-15 13:10:59 +01:00
Kconfig.platforms ARM: DT updates for 5.18 2022-03-23 18:37:22 -07:00
Makefile arm64/xor: use EOR3 instructions when available 2021-12-14 12:14:26 +00:00