mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-12-20 09:34:44 +08:00
d1acd81bd6
When driver is loaded after rmmod some drives are not showing up during discovery. SATA drives are directly attached to the controller connected phys. During device discovery, the IDENTIFY command (qc timeout (cmd 0xec)) is timing out during revalidation. This will trigger abort from host side and controller successfully aborts the command and returns success. Post this successful abort response ATA library decides to mark the disk as NODEV. To overcome this, inside pm8001_scan_start() after phy_start() call, add get start response and wait for few milliseconds to trigger next phy start. This millisecond delay will give sufficient time for the controller state machine to accept next phy start. Link: https://lore.kernel.org/r/20210505120103.24497-1-ajish.koshy@microchip.com Signed-off-by: Ajish Koshy <ajish.koshy@microchip.com> Signed-off-by: Viswas G <viswas.g@microchip.com> Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com> |
||
|---|---|---|
| .. | ||
| Makefile | ||
| pm80xx_hwi.c | ||
| pm80xx_hwi.h | ||
| pm8001_chips.h | ||
| pm8001_ctl.c | ||
| pm8001_ctl.h | ||
| pm8001_defs.h | ||
| pm8001_hwi.c | ||
| pm8001_hwi.h | ||
| pm8001_init.c | ||
| pm8001_sas.c | ||
| pm8001_sas.h | ||