mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-11-15 16:24:13 +08:00
4715f81afc
This reverts commit7a03fe6f48
("clk: rockchip: reset init state before mmc card initialization"). Though not totally obvious from the commit message nor from the source code, that commit appears to be trying to reset the "_drv" MMC clocks to 90 degrees (note that the "_sample" MMC clocks have a shift of 0 so are not touched). The major problem here is that it doesn't properly reset things. The phase is a two bit field and the commit only touches one of the two bits. Thus the commit had the following affect: - phase 0 => phase 90 - phase 90 => phase 90 - phase 180 => phase 270 - phase 270 => phase 270 Things get even weirder if you happen to have a bootloader that was actually using delay elements (should be no reason to, but you never know), since those are additional bits that weren't touched by the original patch. This is unlikely to be what we actually want. Checking on rk3288-veyron devices, I can see that the bootloader leaves these clocks as: - emmc: phase 180 - sdmmc: phase 90 - sdio0: phase 90 Thus on rk3288-veyron devices the commit we're reverting had the effect of changing the eMMC clock to phase 270. This probably explains the scattered reports I've heard of eMMC devices not working on some veyron devices when using the upstream kernel. The original commit was presumably made because previously the kernel didn't touch the "_drv" phase at all and relied on whatever value was there when the kernel started. If someone was using a bootloader that touched the "_drv" phase then, indeed, we should have code in the kernel to fix that. ...and also, to get ideal timings, we should also have the kernel change the phase depending on the speed mode. In fact, that's the subject of a recent patch I posted at <https://patchwork.kernel.org/patch/9075141/>. Ideally, we should take both the patch posted to dw_mmc and this revert. Since those will likely go through different trees, here I describe behavior with the combos: 1. Just this revert: likely will fix rk3288-veyron eMMC on some devices + other cases; might break someone with a strange bootloader that sets the phase to 0 or one that uses delay elements (pretty unpredicable what would happen in that case). 2. Just dw_mmc patch: fixes everyone. Effectly the dw_mmc patch will totally override the broken patch and fix everything. 3. Both patches: fixes everyone. Once dw_mmc is initting properly then any defaults from the clock code doesn't mattery. Fixes:7a03fe6f48
("clk: rockchip: reset init state before mmc card initialization") Signed-off-by: Douglas Anderson <dianders@chromium.org> Reviewed-by: Shawn Lin <shawn.lin@rock-chips.com> [emmc and sdmmc still work on all current boards in mainline after this revert, so they should take precedence over any out-of-tree board that will hopefully again get fixed with the better upcoming dw_mmc change.] Signed-off-by: Heiko Stuebner <heiko@sntech.de>
170 lines
4.6 KiB
C
170 lines
4.6 KiB
C
/*
|
|
* Copyright 2014 Google, Inc
|
|
* Author: Alexandru M Stan <amstan@chromium.org>
|
|
*
|
|
* This program is free software; you can redistribute it and/or modify
|
|
* it under the terms of the GNU General Public License as published by
|
|
* the Free Software Foundation; either version 2 of the License, or
|
|
* (at your option) any later version.
|
|
*
|
|
* This program is distributed in the hope that it will be useful,
|
|
* but WITHOUT ANY WARRANTY; without even the implied warranty of
|
|
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
|
|
* GNU General Public License for more details.
|
|
*/
|
|
|
|
#include <linux/slab.h>
|
|
#include <linux/clk.h>
|
|
#include <linux/clk-provider.h>
|
|
#include <linux/io.h>
|
|
#include <linux/kernel.h>
|
|
#include "clk.h"
|
|
|
|
struct rockchip_mmc_clock {
|
|
struct clk_hw hw;
|
|
void __iomem *reg;
|
|
int id;
|
|
int shift;
|
|
};
|
|
|
|
#define to_mmc_clock(_hw) container_of(_hw, struct rockchip_mmc_clock, hw)
|
|
|
|
#define RK3288_MMC_CLKGEN_DIV 2
|
|
|
|
static unsigned long rockchip_mmc_recalc(struct clk_hw *hw,
|
|
unsigned long parent_rate)
|
|
{
|
|
return parent_rate / RK3288_MMC_CLKGEN_DIV;
|
|
}
|
|
|
|
#define ROCKCHIP_MMC_DELAY_SEL BIT(10)
|
|
#define ROCKCHIP_MMC_DEGREE_MASK 0x3
|
|
#define ROCKCHIP_MMC_DELAYNUM_OFFSET 2
|
|
#define ROCKCHIP_MMC_DELAYNUM_MASK (0xff << ROCKCHIP_MMC_DELAYNUM_OFFSET)
|
|
|
|
#define PSECS_PER_SEC 1000000000000LL
|
|
|
|
/*
|
|
* Each fine delay is between 44ps-77ps. Assume each fine delay is 60ps to
|
|
* simplify calculations. So 45degs could be anywhere between 33deg and 57.8deg.
|
|
*/
|
|
#define ROCKCHIP_MMC_DELAY_ELEMENT_PSEC 60
|
|
|
|
static int rockchip_mmc_get_phase(struct clk_hw *hw)
|
|
{
|
|
struct rockchip_mmc_clock *mmc_clock = to_mmc_clock(hw);
|
|
unsigned long rate = clk_get_rate(hw->clk);
|
|
u32 raw_value;
|
|
u16 degrees;
|
|
u32 delay_num = 0;
|
|
|
|
raw_value = readl(mmc_clock->reg) >> (mmc_clock->shift);
|
|
|
|
degrees = (raw_value & ROCKCHIP_MMC_DEGREE_MASK) * 90;
|
|
|
|
if (raw_value & ROCKCHIP_MMC_DELAY_SEL) {
|
|
/* degrees/delaynum * 10000 */
|
|
unsigned long factor = (ROCKCHIP_MMC_DELAY_ELEMENT_PSEC / 10) *
|
|
36 * (rate / 1000000);
|
|
|
|
delay_num = (raw_value & ROCKCHIP_MMC_DELAYNUM_MASK);
|
|
delay_num >>= ROCKCHIP_MMC_DELAYNUM_OFFSET;
|
|
degrees += DIV_ROUND_CLOSEST(delay_num * factor, 10000);
|
|
}
|
|
|
|
return degrees % 360;
|
|
}
|
|
|
|
static int rockchip_mmc_set_phase(struct clk_hw *hw, int degrees)
|
|
{
|
|
struct rockchip_mmc_clock *mmc_clock = to_mmc_clock(hw);
|
|
unsigned long rate = clk_get_rate(hw->clk);
|
|
u8 nineties, remainder;
|
|
u8 delay_num;
|
|
u32 raw_value;
|
|
u32 delay;
|
|
|
|
nineties = degrees / 90;
|
|
remainder = (degrees % 90);
|
|
|
|
/*
|
|
* Due to the inexact nature of the "fine" delay, we might
|
|
* actually go non-monotonic. We don't go _too_ monotonic
|
|
* though, so we should be OK. Here are options of how we may
|
|
* work:
|
|
*
|
|
* Ideally we end up with:
|
|
* 1.0, 2.0, ..., 69.0, 70.0, ..., 89.0, 90.0
|
|
*
|
|
* On one extreme (if delay is actually 44ps):
|
|
* .73, 1.5, ..., 50.6, 51.3, ..., 65.3, 90.0
|
|
* The other (if delay is actually 77ps):
|
|
* 1.3, 2.6, ..., 88.6. 89.8, ..., 114.0, 90
|
|
*
|
|
* It's possible we might make a delay that is up to 25
|
|
* degrees off from what we think we're making. That's OK
|
|
* though because we should be REALLY far from any bad range.
|
|
*/
|
|
|
|
/*
|
|
* Convert to delay; do a little extra work to make sure we
|
|
* don't overflow 32-bit / 64-bit numbers.
|
|
*/
|
|
delay = 10000000; /* PSECS_PER_SEC / 10000 / 10 */
|
|
delay *= remainder;
|
|
delay = DIV_ROUND_CLOSEST(delay,
|
|
(rate / 1000) * 36 *
|
|
(ROCKCHIP_MMC_DELAY_ELEMENT_PSEC / 10));
|
|
|
|
delay_num = (u8) min_t(u32, delay, 255);
|
|
|
|
raw_value = delay_num ? ROCKCHIP_MMC_DELAY_SEL : 0;
|
|
raw_value |= delay_num << ROCKCHIP_MMC_DELAYNUM_OFFSET;
|
|
raw_value |= nineties;
|
|
writel(HIWORD_UPDATE(raw_value, 0x07ff, mmc_clock->shift),
|
|
mmc_clock->reg);
|
|
|
|
pr_debug("%s->set_phase(%d) delay_nums=%u reg[0x%p]=0x%03x actual_degrees=%d\n",
|
|
clk_hw_get_name(hw), degrees, delay_num,
|
|
mmc_clock->reg, raw_value>>(mmc_clock->shift),
|
|
rockchip_mmc_get_phase(hw)
|
|
);
|
|
|
|
return 0;
|
|
}
|
|
|
|
static const struct clk_ops rockchip_mmc_clk_ops = {
|
|
.recalc_rate = rockchip_mmc_recalc,
|
|
.get_phase = rockchip_mmc_get_phase,
|
|
.set_phase = rockchip_mmc_set_phase,
|
|
};
|
|
|
|
struct clk *rockchip_clk_register_mmc(const char *name,
|
|
const char *const *parent_names, u8 num_parents,
|
|
void __iomem *reg, int shift)
|
|
{
|
|
struct clk_init_data init;
|
|
struct rockchip_mmc_clock *mmc_clock;
|
|
struct clk *clk;
|
|
|
|
mmc_clock = kmalloc(sizeof(*mmc_clock), GFP_KERNEL);
|
|
if (!mmc_clock)
|
|
return ERR_PTR(-ENOMEM);
|
|
|
|
init.name = name;
|
|
init.flags = 0;
|
|
init.num_parents = num_parents;
|
|
init.parent_names = parent_names;
|
|
init.ops = &rockchip_mmc_clk_ops;
|
|
|
|
mmc_clock->hw.init = &init;
|
|
mmc_clock->reg = reg;
|
|
mmc_clock->shift = shift;
|
|
|
|
clk = clk_register(NULL, &mmc_clock->hw);
|
|
if (IS_ERR(clk))
|
|
kfree(mmc_clock);
|
|
|
|
return clk;
|
|
}
|