mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-11-17 09:14:19 +08:00
fb1d9be596
This moves the double fault data used at boot time into a single struct which can then easily be addressed with indexed loads rather than having to explicitly load multiple addresses. Signed-off-by: Mike Frysinger <vapier@gentoo.org>
193 lines
3.8 KiB
ArmAsm
193 lines
3.8 KiB
ArmAsm
/*
|
|
* BF561 coreB bootstrap file
|
|
*
|
|
* Copyright 2007-2009 Analog Devices Inc.
|
|
* Philippe Gerum <rpm@xenomai.org>
|
|
*
|
|
* Licensed under the GPL-2 or later.
|
|
*/
|
|
|
|
#include <linux/linkage.h>
|
|
#include <linux/init.h>
|
|
#include <asm/blackfin.h>
|
|
#include <asm/asm-offsets.h>
|
|
#include <asm/trace.h>
|
|
|
|
/*
|
|
* This code must come first as CoreB is hardcoded (in hardware)
|
|
* to start at the beginning of its L1 instruction memory.
|
|
*/
|
|
.section .l1.text.head
|
|
|
|
/* Lay the initial stack into the L1 scratch area of Core B */
|
|
#define INITIAL_STACK (COREB_L1_SCRATCH_START + L1_SCRATCH_LENGTH - 12)
|
|
|
|
ENTRY(_coreb_trampoline_start)
|
|
/* Enable Cycle Counter and Nesting Of Interrupts */
|
|
#ifdef CONFIG_BFIN_SCRATCH_REG_CYCLES
|
|
R0 = SYSCFG_SNEN;
|
|
#else
|
|
R0 = SYSCFG_SNEN | SYSCFG_CCEN;
|
|
#endif
|
|
SYSCFG = R0;
|
|
|
|
/* Optimization register tricks: keep a base value in the
|
|
* reserved P registers so we use the load/store with an
|
|
* offset syntax. R0 = [P5 + <constant>];
|
|
* P5 - core MMR base
|
|
* R6 - 0
|
|
*/
|
|
r6 = 0;
|
|
p5.l = 0;
|
|
p5.h = hi(COREMMR_BASE);
|
|
|
|
/* Zero out registers required by Blackfin ABI */
|
|
|
|
/* Disable circular buffers */
|
|
L0 = r6;
|
|
L1 = r6;
|
|
L2 = r6;
|
|
L3 = r6;
|
|
|
|
/* Disable hardware loops in case we were started by 'go' */
|
|
LC0 = r6;
|
|
LC1 = r6;
|
|
|
|
/*
|
|
* Clear ITEST_COMMAND and DTEST_COMMAND registers,
|
|
* Leaving these as non-zero can confuse the emulator
|
|
*/
|
|
[p5 + (DTEST_COMMAND - COREMMR_BASE)] = r6;
|
|
[p5 + (ITEST_COMMAND - COREMMR_BASE)] = r6;
|
|
CSYNC;
|
|
|
|
trace_buffer_init(p0,r0);
|
|
|
|
/* Turn off the icache */
|
|
r1 = [p5 + (IMEM_CONTROL - COREMMR_BASE)];
|
|
BITCLR (r1, ENICPLB_P);
|
|
[p5 + (IMEM_CONTROL - COREMMR_BASE)] = r1;
|
|
SSYNC;
|
|
|
|
/* Turn off the dcache */
|
|
r1 = [p5 + (DMEM_CONTROL - COREMMR_BASE)];
|
|
BITCLR (r1, ENDCPLB_P);
|
|
[p5 + (DMEM_CONTROL - COREMMR_BASE)] = r1;
|
|
SSYNC;
|
|
|
|
/* in case of double faults, save a few things */
|
|
p1.l = _initial_pda_coreb;
|
|
p1.h = _initial_pda_coreb;
|
|
r4 = RETX;
|
|
#ifdef CONFIG_DEBUG_DOUBLEFAULT
|
|
/* Only save these if we are storing them,
|
|
* This happens here, since L1 gets clobbered
|
|
* below
|
|
*/
|
|
GET_PDA(p0, r0);
|
|
r0 = [p0 + PDA_DF_RETX];
|
|
r1 = [p0 + PDA_DF_DCPLB];
|
|
r2 = [p0 + PDA_DF_ICPLB];
|
|
r3 = [p0 + PDA_DF_SEQSTAT];
|
|
[p1 + PDA_INIT_DF_RETX] = r0;
|
|
[p1 + PDA_INIT_DF_DCPLB] = r1;
|
|
[p1 + PDA_INIT_DF_ICPLB] = r2;
|
|
[p1 + PDA_INIT_DF_SEQSTAT] = r3;
|
|
#endif
|
|
[p1 + PDA_INIT_RETX] = r4;
|
|
|
|
/* Initialize stack pointer */
|
|
sp.l = lo(INITIAL_STACK);
|
|
sp.h = hi(INITIAL_STACK);
|
|
fp = sp;
|
|
usp = sp;
|
|
|
|
/* This section keeps the processor in supervisor mode
|
|
* during core B startup. Branches to the idle task.
|
|
*/
|
|
|
|
/* EVT15 = _real_start */
|
|
|
|
p1.l = _coreb_start;
|
|
p1.h = _coreb_start;
|
|
[p5 + (EVT15 - COREMMR_BASE)] = p1;
|
|
csync;
|
|
|
|
r0 = EVT_IVG15 (z);
|
|
sti r0;
|
|
|
|
raise 15;
|
|
p0.l = .LWAIT_HERE;
|
|
p0.h = .LWAIT_HERE;
|
|
reti = p0;
|
|
#if defined(ANOMALY_05000281)
|
|
nop; nop; nop;
|
|
#endif
|
|
rti;
|
|
|
|
.LWAIT_HERE:
|
|
jump .LWAIT_HERE;
|
|
ENDPROC(_coreb_trampoline_start)
|
|
|
|
#ifdef CONFIG_HOTPLUG_CPU
|
|
.section ".text"
|
|
ENTRY(_coreb_die)
|
|
sp.l = lo(INITIAL_STACK);
|
|
sp.h = hi(INITIAL_STACK);
|
|
fp = sp;
|
|
usp = sp;
|
|
|
|
CLI R2;
|
|
SSYNC;
|
|
IDLE;
|
|
STI R2;
|
|
|
|
R0 = IWR_DISABLE_ALL;
|
|
P0.H = hi(SYSMMR_BASE);
|
|
P0.L = lo(SYSMMR_BASE);
|
|
[P0 + (SICB_IWR0 - SYSMMR_BASE)] = R0;
|
|
[P0 + (SICB_IWR1 - SYSMMR_BASE)] = R0;
|
|
SSYNC;
|
|
|
|
p0.h = hi(COREB_L1_CODE_START);
|
|
p0.l = lo(COREB_L1_CODE_START);
|
|
jump (p0);
|
|
ENDPROC(_coreb_die)
|
|
#endif
|
|
|
|
__INIT
|
|
ENTRY(_coreb_start)
|
|
[--sp] = reti;
|
|
|
|
p0.l = lo(WDOGB_CTL);
|
|
p0.h = hi(WDOGB_CTL);
|
|
r0 = 0xAD6(z);
|
|
w[p0] = r0; /* Clear the watchdog. */
|
|
ssync;
|
|
|
|
/*
|
|
* switch to IDLE stack.
|
|
*/
|
|
p0.l = _secondary_stack;
|
|
p0.h = _secondary_stack;
|
|
sp = [p0];
|
|
usp = sp;
|
|
fp = sp;
|
|
#ifdef CONFIG_HOTPLUG_CPU
|
|
p0.l = _hotplug_coreb;
|
|
p0.h = _hotplug_coreb;
|
|
r0 = [p0];
|
|
cc = BITTST(r0, 0);
|
|
if cc jump 3f;
|
|
#endif
|
|
sp += -12;
|
|
call _init_pda
|
|
sp += 12;
|
|
#ifdef CONFIG_HOTPLUG_CPU
|
|
3:
|
|
#endif
|
|
call _secondary_start_kernel;
|
|
.L_exit:
|
|
jump.s .L_exit;
|
|
ENDPROC(_coreb_start)
|