mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-11-24 04:34:08 +08:00
530b1dbd97
Chip outputs are enabled[1] before actual reset is performed[2] which might
cause pin output value to flip flop if previous pin value was set to 1.
Fix that behavior by making sure chip is fully reset before all outputs are
enabled.
Flip-flop can be noticed when module is removed and inserted again and one of
the pins was changed to 1 before removal. 100 microsecond flipping is
noticeable on oscilloscope (100khz SPI bus).
For a properly reset chip - output is enabled around 100 microseconds (on 100khz
SPI bus) later during probing process hence should be irrelevant behavioral
change.
Fixes: 7ebc194d0f
(gpio: 74x164: Introduce 'enable-gpios' property)
Link: https://elixir.bootlin.com/linux/v6.7.4/source/drivers/gpio/gpio-74x164.c#L130 [1]
Link: https://elixir.bootlin.com/linux/v6.7.4/source/drivers/gpio/gpio-74x164.c#L150 [2]
Signed-off-by: Arturas Moskvinas <arturas.moskvinas@gmail.com>
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
204 lines
5.0 KiB
C
204 lines
5.0 KiB
C
// SPDX-License-Identifier: GPL-2.0-only
|
|
/*
|
|
* 74Hx164 - Generic serial-in/parallel-out 8-bits shift register GPIO driver
|
|
*
|
|
* Copyright (C) 2010 Gabor Juhos <juhosg@openwrt.org>
|
|
* Copyright (C) 2010 Miguel Gaio <miguel.gaio@efixo.com>
|
|
*/
|
|
|
|
#include <linux/bitops.h>
|
|
#include <linux/gpio/consumer.h>
|
|
#include <linux/gpio/driver.h>
|
|
#include <linux/module.h>
|
|
#include <linux/mutex.h>
|
|
#include <linux/property.h>
|
|
#include <linux/slab.h>
|
|
#include <linux/spi/spi.h>
|
|
|
|
#define GEN_74X164_NUMBER_GPIOS 8
|
|
|
|
struct gen_74x164_chip {
|
|
struct gpio_chip gpio_chip;
|
|
struct mutex lock;
|
|
struct gpio_desc *gpiod_oe;
|
|
u32 registers;
|
|
/*
|
|
* Since the registers are chained, every byte sent will make
|
|
* the previous byte shift to the next register in the
|
|
* chain. Thus, the first byte sent will end up in the last
|
|
* register at the end of the transfer. So, to have a logical
|
|
* numbering, store the bytes in reverse order.
|
|
*/
|
|
u8 buffer[];
|
|
};
|
|
|
|
static int __gen_74x164_write_config(struct gen_74x164_chip *chip)
|
|
{
|
|
return spi_write(to_spi_device(chip->gpio_chip.parent), chip->buffer,
|
|
chip->registers);
|
|
}
|
|
|
|
static int gen_74x164_get_value(struct gpio_chip *gc, unsigned offset)
|
|
{
|
|
struct gen_74x164_chip *chip = gpiochip_get_data(gc);
|
|
u8 bank = chip->registers - 1 - offset / 8;
|
|
u8 pin = offset % 8;
|
|
int ret;
|
|
|
|
mutex_lock(&chip->lock);
|
|
ret = (chip->buffer[bank] >> pin) & 0x1;
|
|
mutex_unlock(&chip->lock);
|
|
|
|
return ret;
|
|
}
|
|
|
|
static void gen_74x164_set_value(struct gpio_chip *gc,
|
|
unsigned offset, int val)
|
|
{
|
|
struct gen_74x164_chip *chip = gpiochip_get_data(gc);
|
|
u8 bank = chip->registers - 1 - offset / 8;
|
|
u8 pin = offset % 8;
|
|
|
|
mutex_lock(&chip->lock);
|
|
if (val)
|
|
chip->buffer[bank] |= (1 << pin);
|
|
else
|
|
chip->buffer[bank] &= ~(1 << pin);
|
|
|
|
__gen_74x164_write_config(chip);
|
|
mutex_unlock(&chip->lock);
|
|
}
|
|
|
|
static void gen_74x164_set_multiple(struct gpio_chip *gc, unsigned long *mask,
|
|
unsigned long *bits)
|
|
{
|
|
struct gen_74x164_chip *chip = gpiochip_get_data(gc);
|
|
unsigned long offset;
|
|
unsigned long bankmask;
|
|
size_t bank;
|
|
unsigned long bitmask;
|
|
|
|
mutex_lock(&chip->lock);
|
|
for_each_set_clump8(offset, bankmask, mask, chip->registers * 8) {
|
|
bank = chip->registers - 1 - offset / 8;
|
|
bitmask = bitmap_get_value8(bits, offset) & bankmask;
|
|
|
|
chip->buffer[bank] &= ~bankmask;
|
|
chip->buffer[bank] |= bitmask;
|
|
}
|
|
__gen_74x164_write_config(chip);
|
|
mutex_unlock(&chip->lock);
|
|
}
|
|
|
|
static int gen_74x164_direction_output(struct gpio_chip *gc,
|
|
unsigned offset, int val)
|
|
{
|
|
gen_74x164_set_value(gc, offset, val);
|
|
return 0;
|
|
}
|
|
|
|
static int gen_74x164_probe(struct spi_device *spi)
|
|
{
|
|
struct gen_74x164_chip *chip;
|
|
u32 nregs;
|
|
int ret;
|
|
|
|
/*
|
|
* bits_per_word cannot be configured in platform data
|
|
*/
|
|
spi->bits_per_word = 8;
|
|
|
|
ret = spi_setup(spi);
|
|
if (ret < 0)
|
|
return ret;
|
|
|
|
ret = device_property_read_u32(&spi->dev, "registers-number", &nregs);
|
|
if (ret) {
|
|
dev_err(&spi->dev, "Missing 'registers-number' property.\n");
|
|
return -EINVAL;
|
|
}
|
|
|
|
chip = devm_kzalloc(&spi->dev, sizeof(*chip) + nregs, GFP_KERNEL);
|
|
if (!chip)
|
|
return -ENOMEM;
|
|
|
|
chip->gpiod_oe = devm_gpiod_get_optional(&spi->dev, "enable",
|
|
GPIOD_OUT_LOW);
|
|
if (IS_ERR(chip->gpiod_oe))
|
|
return PTR_ERR(chip->gpiod_oe);
|
|
|
|
spi_set_drvdata(spi, chip);
|
|
|
|
chip->gpio_chip.label = spi->modalias;
|
|
chip->gpio_chip.direction_output = gen_74x164_direction_output;
|
|
chip->gpio_chip.get = gen_74x164_get_value;
|
|
chip->gpio_chip.set = gen_74x164_set_value;
|
|
chip->gpio_chip.set_multiple = gen_74x164_set_multiple;
|
|
chip->gpio_chip.base = -1;
|
|
|
|
chip->registers = nregs;
|
|
chip->gpio_chip.ngpio = GEN_74X164_NUMBER_GPIOS * chip->registers;
|
|
|
|
chip->gpio_chip.can_sleep = true;
|
|
chip->gpio_chip.parent = &spi->dev;
|
|
chip->gpio_chip.owner = THIS_MODULE;
|
|
|
|
mutex_init(&chip->lock);
|
|
|
|
ret = __gen_74x164_write_config(chip);
|
|
if (ret) {
|
|
dev_err(&spi->dev, "Failed writing: %d\n", ret);
|
|
goto exit_destroy;
|
|
}
|
|
|
|
gpiod_set_value_cansleep(chip->gpiod_oe, 1);
|
|
|
|
ret = gpiochip_add_data(&chip->gpio_chip, chip);
|
|
if (!ret)
|
|
return 0;
|
|
|
|
exit_destroy:
|
|
mutex_destroy(&chip->lock);
|
|
|
|
return ret;
|
|
}
|
|
|
|
static void gen_74x164_remove(struct spi_device *spi)
|
|
{
|
|
struct gen_74x164_chip *chip = spi_get_drvdata(spi);
|
|
|
|
gpiod_set_value_cansleep(chip->gpiod_oe, 0);
|
|
gpiochip_remove(&chip->gpio_chip);
|
|
mutex_destroy(&chip->lock);
|
|
}
|
|
|
|
static const struct spi_device_id gen_74x164_spi_ids[] = {
|
|
{ .name = "74hc595" },
|
|
{ .name = "74lvc594" },
|
|
{},
|
|
};
|
|
MODULE_DEVICE_TABLE(spi, gen_74x164_spi_ids);
|
|
|
|
static const struct of_device_id gen_74x164_dt_ids[] = {
|
|
{ .compatible = "fairchild,74hc595" },
|
|
{ .compatible = "nxp,74lvc594" },
|
|
{},
|
|
};
|
|
MODULE_DEVICE_TABLE(of, gen_74x164_dt_ids);
|
|
|
|
static struct spi_driver gen_74x164_driver = {
|
|
.driver = {
|
|
.name = "74x164",
|
|
.of_match_table = gen_74x164_dt_ids,
|
|
},
|
|
.probe = gen_74x164_probe,
|
|
.remove = gen_74x164_remove,
|
|
.id_table = gen_74x164_spi_ids,
|
|
};
|
|
module_spi_driver(gen_74x164_driver);
|
|
|
|
MODULE_AUTHOR("Gabor Juhos <juhosg@openwrt.org>");
|
|
MODULE_AUTHOR("Miguel Gaio <miguel.gaio@efixo.com>");
|
|
MODULE_DESCRIPTION("GPIO expander driver for 74X164 8-bits shift register");
|
|
MODULE_LICENSE("GPL v2");
|