Cindy H Kao 8b5b30ee7d wimax/i2400m: when bootstrap fails, reinitialize the bootrom ... When a device reset happens during firmware load [in i2400m_dev_bootstrap()], __i2400m_dev_start() will retry a number of times. However, for those retries to be able to accomplish anything, the device's bootrom has to be reinitialized. Thus, on the retry path, pass the I2400M_MAC_REINIT to the firmware load code. Signed-off-by: Cindy H Kao <cindy.h.kao@intel.com>		2009-06-11 03:30:26 -07:00
..
control.c	wimax/i2400m: if a device reboot happens during probe, handle it	2009-06-11 03:30:23 -07:00
debug-levels.h	wimax/i2400m: allow control of the base-station idle mode timeout	2009-03-02 03:10:25 -08:00
debugfs.c	wimax: fix build issue when debugfs is disabled	2009-01-29 17:18:31 -08:00
driver.c	wimax/i2400m: when bootstrap fails, reinitialize the bootrom	2009-06-11 03:30:26 -07:00
fw.c	wimax/i2400m: don't reset device when bootrom init retries are exceeded	2009-06-11 03:30:25 -07:00
i2400m-sdio.h	wimax/i2400m/sdio: Move all the RX code to a unified, IRQ based receive routine	2009-06-11 03:30:25 -07:00
i2400m-usb.h	i2400m/USB: header for the USB bus driver	2009-01-07 10:00:21 -08:00
i2400m.h	wimax/i2400m: move boot time poke table out of common driver	2009-06-11 03:30:24 -07:00
Kconfig	i2400m: Makefile and Kconfig	2009-01-07 10:00:22 -08:00
Makefile	wimax/i2400m: allow control of the base-station idle mode timeout	2009-03-02 03:10:25 -08:00
netdev.c	wimax/i2400m: generate fake source MAC address with random_ether_addr()	2009-05-28 18:01:24 -07:00
op-rfkill.c	i2400m: Generic probe/disconnect, reset and message passing	2009-01-07 10:00:18 -08:00
rx.c	wimax/i2400m: rename misleading I2400M_PL_PAD to I2400M_PL_ALIGN	2009-06-11 03:30:20 -07:00
sdio-debug-levels.h	i2400m/SDIO: header for the SDIO subdriver	2009-01-07 10:00:22 -08:00
sdio-fw.c	wimax/i2400m/sdio: Move all the RX code to a unified, IRQ based receive routine	2009-06-11 03:30:25 -07:00
sdio-rx.c	wimax/i2400m/sdio: Move all the RX code to a unified, IRQ based receive routine	2009-06-11 03:30:25 -07:00
sdio-tx.c	i2400m/SDIO: TX and RX path backends	2009-01-07 10:00:22 -08:00
sdio.c	wimax/i2400m/sdio: Move all the RX code to a unified, IRQ based receive routine	2009-06-11 03:30:25 -07:00
sysfs.c	wimax/i2400m: allow control of the base-station idle mode timeout	2009-03-02 03:10:25 -08:00
tx.c	wimax/i2400m: fix oops when the TX FIFO fills up due to a missing check	2009-06-11 03:30:22 -07:00
usb-debug-levels.h	i2400m/USB: header for the USB bus driver	2009-01-07 10:00:21 -08:00
usb-fw.c	i2400m/USB: firmware upload backend	2009-01-07 10:00:21 -08:00
usb-notif.c	wimax: struct device - replace bus_id with dev_name(), dev_set_name()	2009-03-02 03:10:26 -08:00
usb-rx.c	wimax/i2400m: error paths that need to free an skb should use kfree_skb()	2009-01-19 17:58:08 -08:00
usb-tx.c	i2400m/USB: TX and RX path backends	2009-01-07 10:00:21 -08:00
usb.c	wimax/i2400m: Allow bus-specific driver to specify retry count	2009-06-11 03:30:23 -07:00