mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-12-28 05:24:47 +08:00
10e7122107
Since this documents multiple chips controlled by the isl1208 driver, name it isil,isl1208.txt, as the convention is to use the base driver name in the bindings document for drivers with multiple devices. Include all chips supported by this driver in the docs. Make it clear which properties apply to which chips. Expand documentation for existing isil,evienb property to explain operation in more detail. Existing docs just describe it in terms of setting a bit in a register. CC: Alessandro Zummo <a.zummo@towertech.it> CC: Alexandre Belloni <alexandre.belloni@bootlin.com> CC: Rob Herring <robh+dt@kernel.org> CC: Mark Rutland <mark.rutland@arm.com> CC: devicetree@vger.kernel.org Signed-off-by: Trent Piepho <tpiepho@impinj.com> Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
39 lines
1.3 KiB
Plaintext
39 lines
1.3 KiB
Plaintext
Intersil ISL1209/19 I2C RTC/Alarm chip with event in
|
|
|
|
ISL12X9 have additional pins EVIN and #EVDET for tamper detection, while the
|
|
ISL1208 and ISL1218 do not. They are all use the same driver with the bindings
|
|
described here, with chip specific properties as noted.
|
|
|
|
Required properties supported by the device:
|
|
- "compatible": Should be one of the following:
|
|
- "isil,isl1208"
|
|
- "isil,isl1209"
|
|
- "isil,isl1218"
|
|
- "isil,isl1219"
|
|
- "reg": I2C bus address of the device
|
|
|
|
Optional properties:
|
|
- "interrupt-names": list which may contains "irq" and "evdet"
|
|
evdet applies to isl1209 and isl1219 only
|
|
- "interrupts": list of interrupts for "irq" and "evdet"
|
|
evdet applies to isl1209 and isl1219 only
|
|
- "isil,ev-evienb": Enable or disable internal pull on EVIN pin
|
|
Applies to isl1209 and isl1219 only
|
|
Possible values are 0 and 1
|
|
Value 0 enables internal pull-up on evin pin, 1 disables it.
|
|
Default will leave the non-volatile configuration of the pullup
|
|
as is.
|
|
|
|
Example isl1219 node with #IRQ pin connected to SoC gpio1 pin12 and #EVDET pin
|
|
connected to SoC gpio2 pin 24 and internal pull-up enabled in EVIN pin.
|
|
|
|
isl1219: rtc@68 {
|
|
compatible = "isil,isl1219";
|
|
reg = <0x68>;
|
|
interrupt-names = "irq", "evdet";
|
|
interrupts-extended = <&gpio1 12 IRQ_TYPE_EDGE_FALLING>,
|
|
<&gpio2 24 IRQ_TYPE_EDGE_FALLING>;
|
|
isil,ev-evienb = <1>;
|
|
};
|
|
|