mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-11-18 17:54:13 +08:00
d84248bf46
We have a wifi module connected to the spi bus and got sometimes FIFO overrun errors on the spi bus. After some investigation i found that the driver loads the TCR (transmit count) register before the RCR (receive count). When the transfer list is not empty the atmel_spi_next_message is called while tx and rx are enabled. As soon as the TCR is loaded, hardware starts transfer and causes a rx fifo overrun because the RCR is not loaded yet. Load the RCR before the TCR. After this patch the fifo overrun disapears at out setup. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com> Signed-off-by: Rini van Zetten <rini@arvoo.nl> Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org> |
||
|---|---|---|
| .. | ||
| at25.c | ||
| atmel_spi.c | ||
| atmel_spi.h | ||
| au1550_spi.c | ||
| Kconfig | ||
| Makefile | ||
| mpc52xx_psc_spi.c | ||
| omap2_mcspi.c | ||
| omap_uwire.c | ||
| pxa2xx_spi.c | ||
| spi_bfin5xx.c | ||
| spi_bitbang.c | ||
| spi_butterfly.c | ||
| spi_imx.c | ||
| spi_lm70llp.c | ||
| spi_mpc83xx.c | ||
| spi_s3c24xx_gpio.c | ||
| spi_s3c24xx.c | ||
| spi_txx9.c | ||
| spi.c | ||
| spidev.c | ||
| tle62x0.c | ||
| xilinx_spi.c | ||