mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-12-04 01:24:12 +08:00
70e380250c
When there is no PCIe card connected and advk_pcie_rd_conf() or advk_pcie_wr_conf() is called for PCI bus which doesn't belong to emulated root bridge, the aardvark driver throws the following error message: advk-pcie d0070000.pcie: config read/write timed out Obviously accessing PCIe registers of disconnected card is not possible. Extend check in advk_pcie_valid_device() function for validating availability of PCIe bus. If PCIe link is down, then the device is marked as Not Found and the driver does not try to access these registers. This is just an optimization to prevent accessing PCIe registers when card is disconnected. Trying to access PCIe registers of disconnected card does not cause any crash, kernel just needs to wait for a timeout. So if card disappear immediately after checking for PCIe link (before accessing PCIe registers), it does not cause any problems. Link: https://lore.kernel.org/r/20200702083036.12230-1-pali@kernel.org Signed-off-by: Pali Rohár <pali@kernel.org> Signed-off-by: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com> |
||
---|---|---|
.. | ||
controller | ||
endpoint | ||
hotplug | ||
pcie | ||
switch | ||
access.c | ||
ats.c | ||
bus.c | ||
ecam.c | ||
host-bridge.c | ||
iov.c | ||
irq.c | ||
Kconfig | ||
Makefile | ||
mmap.c | ||
msi.c | ||
of.c | ||
p2pdma.c | ||
pci-acpi.c | ||
pci-bridge-emul.c | ||
pci-bridge-emul.h | ||
pci-driver.c | ||
pci-label.c | ||
pci-mid.c | ||
pci-pf-stub.c | ||
pci-stub.c | ||
pci-sysfs.c | ||
pci.c | ||
pci.h | ||
probe.c | ||
proc.c | ||
quirks.c | ||
remove.c | ||
rom.c | ||
search.c | ||
setup-bus.c | ||
setup-irq.c | ||
setup-res.c | ||
slot.c | ||
syscall.c | ||
vc.c | ||
vpd.c | ||
xen-pcifront.c |