mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-11-17 17:24:17 +08:00
b87d37d023
The Inter-IC Sound Controller (I2SMCC) provides a 5-wire, bidirectional, synchronous, digital audio link to external audio devices: I2SMCC_DIN, I2SMCC_DOUT, I2SMCC_WS, I2SMCC_CK, and I2SMCC_MCK pins. The I2SMCC complies with the Inter-IC Sound (I2S) bus specification and supports a Time Division Multiplexed (TDM) interface with external multi-channel audio codecs. The I2SMCC consists of a receiver, a transmitter and a common clock generator that can be enabled separately to provide Master, Slave or Controller modes with receiver and/or transmitter active. DMA Controller channels, separate for the receiver and for the transmitter, allow a continuous high bit rate data transfer without processor intervention to the following: - Audio CODECs in Master, Slave, or Controller mode - Stereo DAC or ADC through a dedicated I2S serial interface - Multi-channel or multiple stereo DACs or ADCs, using the TDM format This IP is embedded in Microchip's new sam9x60 SoC. Signed-off-by: Codrin Ciubotariu <codrin.ciubotariu@microchip.com> Signed-off-by: Mark Brown <broonie@kernel.org>
127 lines
3.9 KiB
Plaintext
127 lines
3.9 KiB
Plaintext
config SND_ATMEL_SOC
|
|
tristate "SoC Audio for the Atmel System-on-Chip"
|
|
depends on HAS_IOMEM
|
|
help
|
|
Say Y or M if you want to add support for codecs attached to
|
|
the ATMEL SSC interface. You will also need
|
|
to select the audio interfaces to support below.
|
|
|
|
if SND_ATMEL_SOC
|
|
|
|
config SND_ATMEL_SOC_PDC
|
|
tristate
|
|
depends on HAS_DMA
|
|
default m if SND_ATMEL_SOC_SSC_PDC=m && SND_ATMEL_SOC_SSC=m
|
|
default y if SND_ATMEL_SOC_SSC_PDC=y || (SND_ATMEL_SOC_SSC_PDC=m && SND_ATMEL_SOC_SSC=y)
|
|
|
|
config SND_ATMEL_SOC_SSC_PDC
|
|
tristate
|
|
|
|
config SND_ATMEL_SOC_DMA
|
|
tristate
|
|
select SND_SOC_GENERIC_DMAENGINE_PCM
|
|
default m if SND_ATMEL_SOC_SSC_DMA=m && SND_ATMEL_SOC_SSC=m
|
|
default y if SND_ATMEL_SOC_SSC_DMA=y || (SND_ATMEL_SOC_SSC_DMA=m && SND_ATMEL_SOC_SSC=y)
|
|
|
|
config SND_ATMEL_SOC_SSC_DMA
|
|
tristate
|
|
|
|
config SND_ATMEL_SOC_SSC
|
|
tristate
|
|
default y if SND_ATMEL_SOC_SSC_DMA=y || SND_ATMEL_SOC_SSC_PDC=y
|
|
default m if SND_ATMEL_SOC_SSC_DMA=m || SND_ATMEL_SOC_SSC_PDC=m
|
|
|
|
config SND_AT91_SOC_SAM9G20_WM8731
|
|
tristate "SoC Audio support for WM8731-based At91sam9g20 evaluation board"
|
|
depends on ARCH_AT91 || COMPILE_TEST
|
|
depends on ATMEL_SSC && SND_SOC_I2C_AND_SPI
|
|
select SND_ATMEL_SOC_SSC_PDC
|
|
select SND_SOC_WM8731
|
|
help
|
|
Say Y if you want to add support for SoC audio on WM8731-based
|
|
AT91sam9g20 evaluation board.
|
|
|
|
config SND_ATMEL_SOC_WM8904
|
|
tristate "Atmel ASoC driver for boards using WM8904 codec"
|
|
depends on ARCH_AT91 || COMPILE_TEST
|
|
depends on ATMEL_SSC && I2C
|
|
select SND_ATMEL_SOC_SSC_DMA
|
|
select SND_SOC_WM8904
|
|
help
|
|
Say Y if you want to add support for Atmel ASoC driver for boards using
|
|
WM8904 codec.
|
|
|
|
config SND_AT91_SOC_SAM9X5_WM8731
|
|
tristate "SoC Audio support for WM8731-based at91sam9x5 board"
|
|
depends on ARCH_AT91 || COMPILE_TEST
|
|
depends on ATMEL_SSC && SND_SOC_I2C_AND_SPI
|
|
select SND_ATMEL_SOC_SSC_DMA
|
|
select SND_SOC_WM8731
|
|
help
|
|
Say Y if you want to add support for audio SoC on an
|
|
at91sam9x5 based board that is using WM8731 codec.
|
|
|
|
config SND_ATMEL_SOC_CLASSD
|
|
tristate "Atmel ASoC driver for boards using CLASSD"
|
|
depends on ARCH_AT91 || COMPILE_TEST
|
|
select SND_SOC_GENERIC_DMAENGINE_PCM
|
|
select REGMAP_MMIO
|
|
help
|
|
Say Y if you want to add support for Atmel ASoC driver for boards using
|
|
CLASSD.
|
|
|
|
config SND_ATMEL_SOC_PDMIC
|
|
tristate "Atmel ASoC driver for boards using PDMIC"
|
|
depends on OF && (ARCH_AT91 || COMPILE_TEST)
|
|
select SND_SOC_GENERIC_DMAENGINE_PCM
|
|
select REGMAP_MMIO
|
|
help
|
|
Say Y if you want to add support for Atmel ASoC driver for boards using
|
|
PDMIC.
|
|
|
|
config SND_ATMEL_SOC_TSE850_PCM5142
|
|
tristate "ASoC driver for the Axentia TSE-850"
|
|
depends on ARCH_AT91 && OF
|
|
depends on ATMEL_SSC && I2C
|
|
select SND_ATMEL_SOC_SSC_DMA
|
|
select SND_SOC_PCM512x_I2C
|
|
help
|
|
Say Y if you want to add support for the ASoC driver for the
|
|
Axentia TSE-850 with a PCM5142 codec.
|
|
|
|
config SND_ATMEL_SOC_I2S
|
|
tristate "Atmel ASoC driver for boards using I2S"
|
|
depends on OF && (ARCH_AT91 || COMPILE_TEST)
|
|
select SND_SOC_GENERIC_DMAENGINE_PCM
|
|
select REGMAP_MMIO
|
|
help
|
|
Say Y or M if you want to add support for Atmel ASoc driver for boards
|
|
using I2S.
|
|
|
|
config SND_SOC_MIKROE_PROTO
|
|
tristate "Support for Mikroe-PROTO board"
|
|
depends on OF
|
|
depends on SND_SOC_I2C_AND_SPI
|
|
select SND_SOC_WM8731
|
|
help
|
|
Say Y or M if you want to add support for MikroElektronika PROTO Audio
|
|
Board. This board contains the WM8731 codec, which can be configured
|
|
using I2C over SDA (MPU Data Input) and SCL (MPU Clock Input) pins.
|
|
Both playback and capture are supported.
|
|
|
|
config SND_MCHP_SOC_I2S_MCC
|
|
tristate "Microchip ASoC driver for boards using I2S MCC"
|
|
depends on OF && (ARCH_AT91 || COMPILE_TEST)
|
|
select SND_SOC_GENERIC_DMAENGINE_PCM
|
|
select REGMAP_MMIO
|
|
help
|
|
Say Y or M if you want to add support for I2S Multi-Channel ASoC
|
|
driver on the following Microchip platforms:
|
|
- sam9x60
|
|
|
|
The I2SMCC complies with the Inter-IC Sound (I2S) bus specification
|
|
and supports a Time Division Multiplexed (TDM) interface with
|
|
external multi-channel audio codecs.
|
|
|
|
endif
|