mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-12-14 14:34:28 +08:00
6496ebd7ed
One some systems, the firmware does not allow certain PCI devices to be put in deep D-states. This can cause problems for wakeup signalling, if the device does not support PME# in the deepest allowed suspend state. For example, Pierre reports that on his system, ACPI does not permit his xHCI host controller to go into D3 during runtime suspend -- but D3 is the only state in which the controller can generate PME# signals. As a result, the controller goes into runtime suspend but never wakes up, so it doesn't work properly. USB devices plugged into the controller are never detected. If the device relies on PME# for wakeup signals but is not capable of generating PME# in the target state, the PCI core should accurately report that it cannot do wakeup from runtime suspend. This patch modifies the pci_dev_run_wake() routine to add this check. Reported-by: Pierre de Villemereuil <flyos@mailoo.org> Tested-by: Pierre de Villemereuil <flyos@mailoo.org> Signed-off-by: Alan Stern <stern@rowland.harvard.edu> Signed-off-by: Bjorn Helgaas <bhelgaas@google.com> Acked-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com> CC: stable@vger.kernel.org CC: Lukas Wunner <lukas@wunner.de> |
||
|---|---|---|
| .. | ||
| host | ||
| hotplug | ||
| pcie | ||
| access.c | ||
| ats.c | ||
| bus.c | ||
| ecam.c | ||
| host-bridge.c | ||
| hotplug-pci.c | ||
| htirq.c | ||
| iov.c | ||
| irq.c | ||
| Kconfig | ||
| Makefile | ||
| msi.c | ||
| of.c | ||
| pci-acpi.c | ||
| pci-driver.c | ||
| pci-label.c | ||
| pci-mid.c | ||
| pci-stub.c | ||
| pci-sysfs.c | ||
| pci.c | ||
| pci.h | ||
| probe.c | ||
| proc.c | ||
| quirks.c | ||
| remove.c | ||
| rom.c | ||
| search.c | ||
| setup-bus.c | ||
| setup-irq.c | ||
| setup-res.c | ||
| slot.c | ||
| syscall.c | ||
| vc.c | ||
| vpd.c | ||
| xen-pcifront.c | ||