linux/drivers/net/wireless/ath/ath5k
Felix Fietkau 5c17ddc4a0 ath5k: do not re-run AGC calibration periodically
All other Atheros drivers run the AGC gain calibration and DC offset
calibration only after reset. Running them periodically has caused stability
issues on some (primarily AR2315/2413/5413/5414 based) devices, leading to
messages such as:

ath5k phy0: gain calibration timeout (2462MHz)
ath5k phy0: calibration of channel 11 failed

Related bug reports:
https://dev.openwrt.org/ticket/10574
https://bugzilla.redhat.com/show_bug.cgi?id=795141

Signed-off-by: Felix Fietkau <nbd@openwrt.org>
Acked-by: Nick Kossifidis <mickflemm@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
2012-03-06 15:16:18 -05:00
..
ahb.c ath5k:Remove __raw_read and __raw_write 2012-02-22 14:51:19 -05:00
ani.c ath5k: ath5k_ani_period_restart only touches struct ath5k_ani_state 2011-11-28 14:44:21 -05:00
ani.h ath5k: Cleanups v2 + add kerneldoc on all hw functions 2011-11-28 14:44:16 -05:00
ath5k.h ath5k: allow AP and mesh mode to operate simultaneously 2012-03-06 15:16:05 -05:00
attach.c ath5k: MRR support and 2GHz radio override belong in ah_capabilities 2011-11-28 14:44:19 -05:00
base.c ath5k: do not stop queues for full calibration 2012-03-06 15:16:17 -05:00
base.h ath5k: remove last references to "softc" 2011-08-08 16:04:14 -04:00
caps.c ath5k: MRR support and 2GHz radio override belong in ah_capabilities 2011-11-28 14:44:19 -05:00
debug.c drivers/net: wireless/ath/ath5k/debug.c does not need module.h 2011-10-31 19:31:09 -04:00
debug.h treewide: use __printf not __attribute__((format(printf,...))) 2011-10-31 17:30:54 -07:00
desc.c ath5k: Cleanups v2 + add kerneldoc on all hw functions 2011-11-28 14:44:16 -05:00
desc.h ath5k: Cleanups v2 + add kerneldoc on all hw functions 2011-11-28 14:44:16 -05:00
dma.c ath5k: Cleanups v2 + add kerneldoc on all hw functions 2011-11-28 14:44:16 -05:00
eeprom.c ath5k: clean up base.h and its use 2011-08-08 16:04:14 -04:00
eeprom.h ath5k: fix typos, bad comment formatting and GHz in place of MHz 2011-07-11 15:02:16 -04:00
gpio.c ath5k: Cleanups v2 + add kerneldoc on all hw functions 2011-11-28 14:44:16 -05:00
initvals.c ath5k: Cleanups v2 + add kerneldoc on all hw functions 2011-11-28 14:44:16 -05:00
Kconfig ath5k: use tracing for packet tx/rx dump 2011-01-28 15:44:27 -05:00
led.c ath5k: clean up base.h and its use 2011-08-08 16:04:14 -04:00
mac80211-ops.c ath5k: allow AP and mesh mode to operate simultaneously 2012-03-06 15:16:05 -05:00
Makefile
pci.c ath5k: Use usleep_range where possible 2011-11-28 14:44:15 -05:00
pcu.c ath5k: Cleanups v2 + add kerneldoc on all hw functions 2011-11-28 14:44:16 -05:00
phy.c ath5k: do not re-run AGC calibration periodically 2012-03-06 15:16:18 -05:00
qcu.c ath5k: Optimize ath5k_cw_validate 2011-11-28 14:44:23 -05:00
reg.h ath5k: Switch from read-and-clear to write-to-clear method when handling PISR/SISR registers 2011-11-28 14:44:10 -05:00
reset.c ath5k:Remove __raw_read and __raw_write 2012-02-22 14:51:19 -05:00
rfbuffer.h ath5k: Cleanups v2 + add kerneldoc on all hw functions 2011-11-28 14:44:16 -05:00
rfgain.h ath5k: Cleanups v2 + add kerneldoc on all hw functions 2011-11-28 14:44:16 -05:00
rfkill.c ath5k: clean up base.h and its use 2011-08-08 16:04:14 -04:00
sysfs.c ath5k: clean up base.h and its use 2011-08-08 16:04:14 -04:00
trace.h ath5k: avoid sparse warnings on tracing 2012-01-04 14:30:40 -05:00