mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-12-29 05:55:02 +08:00
623bef9e03
When the USB 3.0 hub support went in, I disabled selective suspend for all external USB 3.0 hubs because they used a different mechanism to enable remote wakeup. In fact, other USB 3.0 devices that could signal remote wakeup would have been prevented from going into suspend because they would have stalled the SetFeature Device Remote Wakeup request. This patch adds support for the USB 3.0 way of enabling remote wake up (with a SetFeature Function Suspend request), and enables selective suspend for all hubs during hub_probe. It assumes that all USB 3.0 have only one "function" as defined by the interface association descriptor, which is true of all the USB 3.0 devices I've seen so far. FIXME if that turns out to change later. After a device signals a remote wakeup, it is supposed to send a Device Notification packet to the host controller, signaling which function sent the remote wakeup. The host can then put any other functions back into function suspend. Since we don't have support for function suspend (and no devices currently support it), we'll just assume the hub function will resume the device properly when it received the port status change notification, and simply ignore any device notification events from the xHCI host controller. Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com> |
||
|---|---|---|
| .. | ||
| buffer.c | ||
| config.c | ||
| devices.c | ||
| devio.c | ||
| driver.c | ||
| endpoint.c | ||
| file.c | ||
| generic.c | ||
| hcd-pci.c | ||
| hcd.c | ||
| hub.c | ||
| inode.c | ||
| Kconfig | ||
| Makefile | ||
| message.c | ||
| notify.c | ||
| otg_whitelist.h | ||
| quirks.c | ||
| sysfs.c | ||
| urb.c | ||
| usb.c | ||
| usb.h | ||