linux/drivers/mux/Kconfig
Peter Rosin afda08c4ca mux: adg792a: add mux controller driver for ADG792A/G
Analog Devices ADG792A/G is a triple 4:1 mux.

Reviewed-by: Jonathan Cameron <jic23@kernel.org>
Signed-off-by: Peter Rosin <peda@axentia.se>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2017-06-03 19:29:26 +09:00

47 lines
1.4 KiB
Plaintext

#
# Multiplexer devices
#
menuconfig MULTIPLEXER
tristate "Multiplexer subsystem"
help
Multiplexer controller subsystem. Multiplexers are used in a
variety of settings, and this subsystem abstracts their use
so that the rest of the kernel sees a common interface. When
multiple parallel multiplexers are controlled by one single
multiplexer controller, this subsystem also coordinates the
multiplexer accesses.
To compile the subsystem as a module, choose M here: the module will
be called mux-core.
if MULTIPLEXER
config MUX_ADG792A
tristate "Analog Devices ADG792A/ADG792G Multiplexers"
depends on I2C || COMPILE_TEST
help
ADG792A and ADG792G Wide Bandwidth Triple 4:1 Multiplexers
The driver supports both operating the three multiplexers in
parallel and operating them independently.
To compile the driver as a module, choose M here: the module will
be called mux-adg792a.
config MUX_GPIO
tristate "GPIO-controlled Multiplexer"
depends on GPIOLIB || COMPILE_TEST
help
GPIO-controlled Multiplexer controller.
The driver builds a single multiplexer controller using a number
of gpio pins. For N pins, there will be 2^N possible multiplexer
states. The GPIO pins can be connected (by the hardware) to several
multiplexers, which in that case will be operated in parallel.
To compile the driver as a module, choose M here: the module will
be called mux-gpio.
endif