linux/arch/arm/mach-imx/avic.c
Martin Kaiser 9b454d16e5 ARM: imx: avic: set low-power interrupt mask for imx25
imx25 contains two registers (LPIMR0 and 1) to define which interrupts
are enabled in low-power mode. As of today, those two registers are
configured to enable all interrupts. Before going to low-power mode, the
AVIC's INTENABLEH and INTENABLEL registers are configured to enable only
those interrupts which are used as wakeup sources.

It turned out that this approach is not sufficient if we want the imx25
to go into stop mode during suspend-to-ram. (Stop mode is the low-power
mode that consumes the least power. The peripheral master clock is
switched off in this mode). For stop mode to work, the LPIMR0 and 1
registers have to be configured with the set of interrupts that are
allowed in low-power mode. Fortunately, the bits in the LPIMR registers
are assigned to the same interrupts as the bits in INTENABLEH and
INTENABLEL. However, LPIMR uses 1 to mask an interrupt whereas the
INTENABLE registers use 1 to enable an interrupt.

This patch sets the LPIMR registers to the inverted bitmask of the
INTENABLE registers during suspend and goes back to "all interrupts
masked" when we wake up again. We also make this the default at startup.

As far as I know, the other supported imx architectures have no similar
mechanism. Since the LPIMR registers are part of the CCM module, we
query the device tree for an imx25 ccm node in order to detect if we're
running on imx25.

Signed-off-by: Martin Kaiser <martin@kaiser.cx>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
2018-02-28 08:55:01 +08:00

236 lines
6.8 KiB
C

/*
* Copyright 2004-2007 Freescale Semiconductor, Inc. All Rights Reserved.
* Copyright 2008 Juergen Beisert, kernel@pengutronix.de
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License
* as published by the Free Software Foundation; either version 2
* of the License, or (at your option) any later version.
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston,
* MA 02110-1301, USA.
*/
#include <linux/module.h>
#include <linux/irq.h>
#include <linux/irqdomain.h>
#include <linux/io.h>
#include <linux/of.h>
#include <linux/of_address.h>
#include <asm/mach/irq.h>
#include <asm/exception.h>
#include "common.h"
#include "hardware.h"
#include "irq-common.h"
#define AVIC_INTCNTL 0x00 /* int control reg */
#define AVIC_NIMASK 0x04 /* int mask reg */
#define AVIC_INTENNUM 0x08 /* int enable number reg */
#define AVIC_INTDISNUM 0x0C /* int disable number reg */
#define AVIC_INTENABLEH 0x10 /* int enable reg high */
#define AVIC_INTENABLEL 0x14 /* int enable reg low */
#define AVIC_INTTYPEH 0x18 /* int type reg high */
#define AVIC_INTTYPEL 0x1C /* int type reg low */
#define AVIC_NIPRIORITY(x) (0x20 + 4 * (7 - (x))) /* int priority */
#define AVIC_NIVECSR 0x40 /* norm int vector/status */
#define AVIC_FIVECSR 0x44 /* fast int vector/status */
#define AVIC_INTSRCH 0x48 /* int source reg high */
#define AVIC_INTSRCL 0x4C /* int source reg low */
#define AVIC_INTFRCH 0x50 /* int force reg high */
#define AVIC_INTFRCL 0x54 /* int force reg low */
#define AVIC_NIPNDH 0x58 /* norm int pending high */
#define AVIC_NIPNDL 0x5C /* norm int pending low */
#define AVIC_FIPNDH 0x60 /* fast int pending high */
#define AVIC_FIPNDL 0x64 /* fast int pending low */
#define AVIC_NUM_IRQS 64
/* low power interrupt mask registers */
#define MX25_CCM_LPIMR0 0x68
#define MX25_CCM_LPIMR1 0x6C
static void __iomem *avic_base;
static void __iomem *mx25_ccm_base;
static struct irq_domain *domain;
#ifdef CONFIG_FIQ
static int avic_set_irq_fiq(unsigned int hwirq, unsigned int type)
{
unsigned int irqt;
if (hwirq >= AVIC_NUM_IRQS)
return -EINVAL;
if (hwirq < AVIC_NUM_IRQS / 2) {
irqt = imx_readl(avic_base + AVIC_INTTYPEL) & ~(1 << hwirq);
imx_writel(irqt | (!!type << hwirq), avic_base + AVIC_INTTYPEL);
} else {
hwirq -= AVIC_NUM_IRQS / 2;
irqt = imx_readl(avic_base + AVIC_INTTYPEH) & ~(1 << hwirq);
imx_writel(irqt | (!!type << hwirq), avic_base + AVIC_INTTYPEH);
}
return 0;
}
#endif /* CONFIG_FIQ */
static struct mxc_extra_irq avic_extra_irq = {
#ifdef CONFIG_FIQ
.set_irq_fiq = avic_set_irq_fiq,
#endif
};
#ifdef CONFIG_PM
static u32 avic_saved_mask_reg[2];
static void avic_irq_suspend(struct irq_data *d)
{
struct irq_chip_generic *gc = irq_data_get_irq_chip_data(d);
struct irq_chip_type *ct = gc->chip_types;
int idx = d->hwirq >> 5;
avic_saved_mask_reg[idx] = imx_readl(avic_base + ct->regs.mask);
imx_writel(gc->wake_active, avic_base + ct->regs.mask);
if (mx25_ccm_base) {
u8 offs = d->hwirq < AVIC_NUM_IRQS / 2 ?
MX25_CCM_LPIMR0 : MX25_CCM_LPIMR1;
/*
* The interrupts which are still enabled will be used as wakeup
* sources. Allow those interrupts in low-power mode.
* The LPIMR registers use 0 to allow an interrupt, the AVIC
* registers use 1.
*/
imx_writel(~gc->wake_active, mx25_ccm_base + offs);
}
}
static void avic_irq_resume(struct irq_data *d)
{
struct irq_chip_generic *gc = irq_data_get_irq_chip_data(d);
struct irq_chip_type *ct = gc->chip_types;
int idx = d->hwirq >> 5;
imx_writel(avic_saved_mask_reg[idx], avic_base + ct->regs.mask);
if (mx25_ccm_base) {
u8 offs = d->hwirq < AVIC_NUM_IRQS / 2 ?
MX25_CCM_LPIMR0 : MX25_CCM_LPIMR1;
imx_writel(0xffffffff, mx25_ccm_base + offs);
}
}
#else
#define avic_irq_suspend NULL
#define avic_irq_resume NULL
#endif
static __init void avic_init_gc(int idx, unsigned int irq_start)
{
struct irq_chip_generic *gc;
struct irq_chip_type *ct;
gc = irq_alloc_generic_chip("mxc-avic", 1, irq_start, avic_base,
handle_level_irq);
gc->private = &avic_extra_irq;
gc->wake_enabled = IRQ_MSK(32);
ct = gc->chip_types;
ct->chip.irq_mask = irq_gc_mask_clr_bit;
ct->chip.irq_unmask = irq_gc_mask_set_bit;
ct->chip.irq_ack = irq_gc_mask_clr_bit;
ct->chip.irq_set_wake = irq_gc_set_wake;
ct->chip.irq_suspend = avic_irq_suspend;
ct->chip.irq_resume = avic_irq_resume;
ct->regs.mask = !idx ? AVIC_INTENABLEL : AVIC_INTENABLEH;
ct->regs.ack = ct->regs.mask;
irq_setup_generic_chip(gc, IRQ_MSK(32), 0, IRQ_NOREQUEST, 0);
}
static void __exception_irq_entry avic_handle_irq(struct pt_regs *regs)
{
u32 nivector;
do {
nivector = imx_readl(avic_base + AVIC_NIVECSR) >> 16;
if (nivector == 0xffff)
break;
handle_domain_irq(domain, nivector, regs);
} while (1);
}
/*
* This function initializes the AVIC hardware and disables all the
* interrupts. It registers the interrupt enable and disable functions
* to the kernel for each interrupt source.
*/
void __init mxc_init_irq(void __iomem *irqbase)
{
struct device_node *np;
int irq_base;
int i;
avic_base = irqbase;
np = of_find_compatible_node(NULL, NULL, "fsl,imx25-ccm");
mx25_ccm_base = of_iomap(np, 0);
if (mx25_ccm_base) {
/*
* By default, we mask all interrupts. We set the actual mask
* before we go into low-power mode.
*/
imx_writel(0xffffffff, mx25_ccm_base + MX25_CCM_LPIMR0);
imx_writel(0xffffffff, mx25_ccm_base + MX25_CCM_LPIMR1);
}
/* put the AVIC into the reset value with
* all interrupts disabled
*/
imx_writel(0, avic_base + AVIC_INTCNTL);
imx_writel(0x1f, avic_base + AVIC_NIMASK);
/* disable all interrupts */
imx_writel(0, avic_base + AVIC_INTENABLEH);
imx_writel(0, avic_base + AVIC_INTENABLEL);
/* all IRQ no FIQ */
imx_writel(0, avic_base + AVIC_INTTYPEH);
imx_writel(0, avic_base + AVIC_INTTYPEL);
irq_base = irq_alloc_descs(-1, 0, AVIC_NUM_IRQS, numa_node_id());
WARN_ON(irq_base < 0);
np = of_find_compatible_node(NULL, NULL, "fsl,avic");
domain = irq_domain_add_legacy(np, AVIC_NUM_IRQS, irq_base, 0,
&irq_domain_simple_ops, NULL);
WARN_ON(!domain);
for (i = 0; i < AVIC_NUM_IRQS / 32; i++, irq_base += 32)
avic_init_gc(i, irq_base);
/* Set default priority value (0) for all IRQ's */
for (i = 0; i < 8; i++)
imx_writel(0, avic_base + AVIC_NIPRIORITY(i));
set_handle_irq(avic_handle_irq);
#ifdef CONFIG_FIQ
/* Initialize FIQ */
init_FIQ(FIQ_START);
#endif
printk(KERN_INFO "MXC IRQ initialized\n");
}