mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-11-16 00:34:20 +08:00
99a700bcc7
In the OCZ RevoDrive3/zDrive R4 series, the "OCZ SuperScale Storage Controller" with "Virtualized Controller Architecture 2.0" really seems to be a Marvell 88SE9485 part, with OCZ firmware/BIOS. Developed and tested on OCZ RevoDrive3 120GB [PCI 1b85:1021] Should work on: - OCZ RevoDrive3 (2x SandForce 2281) - OCZ RevoDrive3 X2 (4x SandForce 2281) - OCZ zDrive R4 CM84 (4x SandForce 2281) - OCZ zDrive R4 CM88 (8x SandForce 2281) - OCZ zDrive R4 RM84 (4x SandForce 2582) - OCZ zDrive R4 RM88 (8x SandForce 2582) All of this because a friend recently bought a OCZ RevoDrive3 and was bitten by the lack of Linux support. Notes from testing: ------------------- - SMART works. - VPD Device Identification is "OCZ-REVODRIVE3" - Thin provisioning/TRIM seems to be implemented as WRITE SAME UNMAP, with deterministic (non-zero) read after TRIM, but I'm not sure if it works 100% in my testing. - Some of the tuning in the firmware seems to ensure much better performance when in a RAID0 setup than using the two devices seperately. I have not tested booting from the SSD, because all of this was developed and tested remotely from the actual hardware. Signed-off-by: Robin H. Johnson <robbat2@gentoo.org> Thanks-To: Gordon Pritchard <gordp@sfu.ca> Acked-by: Xiangliang Yu <yuxiangl@marvell.com> Signed-off-by: James Bottomley <JBottomley@Parallels.com> |
||
|---|---|---|
| .. | ||
| Kconfig | ||
| Makefile | ||
| mv_64xx.c | ||
| mv_64xx.h | ||
| mv_94xx.c | ||
| mv_94xx.h | ||
| mv_chips.h | ||
| mv_defs.h | ||
| mv_init.c | ||
| mv_sas.c | ||
| mv_sas.h | ||