mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-11-15 16:24:13 +08:00
fead4dd496
The WPCM450 AIC ("Advanced Interrupt Controller") is the interrupt controller found in the Nuvoton WPCM450 SoC and other Winbond/Nuvoton SoCs. The list of registers if based on the AMI vendor kernel and the Nuvoton W90N745 datasheet. Although the hardware supports other interrupt modes, the driver only supports high-level interrupts at the moment, because other modes could not be tested so far. Signed-off-by: Jonathan Neuschäfer <j.neuschaefer@gmx.net> Signed-off-by: Marc Zyngier <maz@kernel.org> Link: https://lore.kernel.org/r/20210406120921.2484986-7-j.neuschaefer@gmx.net
162 lines
4.3 KiB
C
162 lines
4.3 KiB
C
// SPDX-License-Identifier: GPL-2.0-only
|
|
// Copyright 2021 Jonathan Neuschäfer
|
|
|
|
#include <linux/irqchip.h>
|
|
#include <linux/of_address.h>
|
|
#include <linux/of_irq.h>
|
|
#include <linux/printk.h>
|
|
|
|
#include <asm/exception.h>
|
|
|
|
#define AIC_SCR(x) ((x)*4) /* Source control registers */
|
|
#define AIC_GEN 0x84 /* Interrupt group enable control register */
|
|
#define AIC_GRSR 0x88 /* Interrupt group raw status register */
|
|
#define AIC_IRSR 0x100 /* Interrupt raw status register */
|
|
#define AIC_IASR 0x104 /* Interrupt active status register */
|
|
#define AIC_ISR 0x108 /* Interrupt status register */
|
|
#define AIC_IPER 0x10c /* Interrupt priority encoding register */
|
|
#define AIC_ISNR 0x110 /* Interrupt source number register */
|
|
#define AIC_IMR 0x114 /* Interrupt mask register */
|
|
#define AIC_OISR 0x118 /* Output interrupt status register */
|
|
#define AIC_MECR 0x120 /* Mask enable command register */
|
|
#define AIC_MDCR 0x124 /* Mask disable command register */
|
|
#define AIC_SSCR 0x128 /* Source set command register */
|
|
#define AIC_SCCR 0x12c /* Source clear command register */
|
|
#define AIC_EOSCR 0x130 /* End of service command register */
|
|
|
|
#define AIC_SCR_SRCTYPE_LOW_LEVEL (0 << 6)
|
|
#define AIC_SCR_SRCTYPE_HIGH_LEVEL (1 << 6)
|
|
#define AIC_SCR_SRCTYPE_NEG_EDGE (2 << 6)
|
|
#define AIC_SCR_SRCTYPE_POS_EDGE (3 << 6)
|
|
#define AIC_SCR_PRIORITY(x) (x)
|
|
#define AIC_SCR_PRIORITY_MASK 0x7
|
|
|
|
#define AIC_NUM_IRQS 32
|
|
|
|
struct wpcm450_aic {
|
|
void __iomem *regs;
|
|
struct irq_domain *domain;
|
|
};
|
|
|
|
static struct wpcm450_aic *aic;
|
|
|
|
static void wpcm450_aic_init_hw(void)
|
|
{
|
|
int i;
|
|
|
|
/* Disable (mask) all interrupts */
|
|
writel(0xffffffff, aic->regs + AIC_MDCR);
|
|
|
|
/*
|
|
* Make sure the interrupt controller is ready to serve new interrupts.
|
|
* Reading from IPER indicates that the nIRQ signal may be deasserted,
|
|
* and writing to EOSCR indicates that interrupt handling has finished.
|
|
*/
|
|
readl(aic->regs + AIC_IPER);
|
|
writel(0, aic->regs + AIC_EOSCR);
|
|
|
|
/* Initialize trigger mode and priority of each interrupt source */
|
|
for (i = 0; i < AIC_NUM_IRQS; i++)
|
|
writel(AIC_SCR_SRCTYPE_HIGH_LEVEL | AIC_SCR_PRIORITY(7),
|
|
aic->regs + AIC_SCR(i));
|
|
}
|
|
|
|
static void __exception_irq_entry wpcm450_aic_handle_irq(struct pt_regs *regs)
|
|
{
|
|
int hwirq;
|
|
|
|
/* Determine the interrupt source */
|
|
/* Read IPER to signal that nIRQ can be de-asserted */
|
|
hwirq = readl(aic->regs + AIC_IPER) / 4;
|
|
|
|
handle_domain_irq(aic->domain, hwirq, regs);
|
|
}
|
|
|
|
static void wpcm450_aic_eoi(struct irq_data *d)
|
|
{
|
|
/* Signal end-of-service */
|
|
writel(0, aic->regs + AIC_EOSCR);
|
|
}
|
|
|
|
static void wpcm450_aic_mask(struct irq_data *d)
|
|
{
|
|
unsigned int mask = BIT(d->hwirq);
|
|
|
|
/* Disable (mask) the interrupt */
|
|
writel(mask, aic->regs + AIC_MDCR);
|
|
}
|
|
|
|
static void wpcm450_aic_unmask(struct irq_data *d)
|
|
{
|
|
unsigned int mask = BIT(d->hwirq);
|
|
|
|
/* Enable (unmask) the interrupt */
|
|
writel(mask, aic->regs + AIC_MECR);
|
|
}
|
|
|
|
static int wpcm450_aic_set_type(struct irq_data *d, unsigned int flow_type)
|
|
{
|
|
/*
|
|
* The hardware supports high/low level, as well as rising/falling edge
|
|
* modes, and the DT binding accommodates for that, but as long as
|
|
* other modes than high level mode are not used and can't be tested,
|
|
* they are rejected in this driver.
|
|
*/
|
|
if ((flow_type & IRQ_TYPE_SENSE_MASK) != IRQ_TYPE_LEVEL_HIGH)
|
|
return -EINVAL;
|
|
|
|
return 0;
|
|
}
|
|
|
|
static struct irq_chip wpcm450_aic_chip = {
|
|
.name = "wpcm450-aic",
|
|
.irq_eoi = wpcm450_aic_eoi,
|
|
.irq_mask = wpcm450_aic_mask,
|
|
.irq_unmask = wpcm450_aic_unmask,
|
|
.irq_set_type = wpcm450_aic_set_type,
|
|
};
|
|
|
|
static int wpcm450_aic_map(struct irq_domain *d, unsigned int irq, irq_hw_number_t hwirq)
|
|
{
|
|
if (hwirq >= AIC_NUM_IRQS)
|
|
return -EPERM;
|
|
|
|
irq_set_chip_and_handler(irq, &wpcm450_aic_chip, handle_fasteoi_irq);
|
|
irq_set_chip_data(irq, aic);
|
|
irq_set_probe(irq);
|
|
|
|
return 0;
|
|
}
|
|
|
|
static const struct irq_domain_ops wpcm450_aic_ops = {
|
|
.map = wpcm450_aic_map,
|
|
.xlate = irq_domain_xlate_twocell,
|
|
};
|
|
|
|
static int __init wpcm450_aic_of_init(struct device_node *node,
|
|
struct device_node *parent)
|
|
{
|
|
if (parent)
|
|
return -EINVAL;
|
|
|
|
aic = kzalloc(sizeof(*aic), GFP_KERNEL);
|
|
if (!aic)
|
|
return -ENOMEM;
|
|
|
|
aic->regs = of_iomap(node, 0);
|
|
if (!aic->regs) {
|
|
pr_err("Failed to map WPCM450 AIC registers\n");
|
|
return -ENOMEM;
|
|
}
|
|
|
|
wpcm450_aic_init_hw();
|
|
|
|
set_handle_irq(wpcm450_aic_handle_irq);
|
|
|
|
aic->domain = irq_domain_add_linear(node, AIC_NUM_IRQS, &wpcm450_aic_ops, aic);
|
|
|
|
return 0;
|
|
}
|
|
|
|
IRQCHIP_DECLARE(wpcm450_aic, "nuvoton,wpcm450-aic", wpcm450_aic_of_init);
|