mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-11-15 16:24:13 +08:00
2808b0a96a
The Marvell bridge chips used on HighPoint SATA cards do not seem to support the UltraDMA modes 1, 2, and 3 as well as any MWDMA modes, so the driver needs to account for this in the udma_filter() method. In order to achieve that, do the following changes: - install the method for all chips, not only HPT36x/370 and improve the code formatting by killing the extra tabs while at it; - add to the end of the 'switch' statement in the method cases for HPT372[AN] and HPT374 chips upon which the known SATA cards are based; - use hwif->ultra_mask as a default mask for the ide_dma_filter() method to behave correctly; - move the HPT370[A] cases below the HPT36x case for consistency. While at it, replace the explicit UltraDMA mode masks with ATA_UDMA* constants all over the driver... Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com> Cc: Bob Ham <rah@bash.sh> Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com> |
||
|---|---|---|
| .. | ||
| arm | ||
| cris | ||
| h8300 | ||
| legacy | ||
| mips | ||
| pci | ||
| ppc | ||
| ide-acpi.c | ||
| ide-cd.c | ||
| ide-cd.h | ||
| ide-disk.c | ||
| ide-dma.c | ||
| ide-floppy.c | ||
| ide-generic.c | ||
| ide-io.c | ||
| ide-iops.c | ||
| ide-lib.c | ||
| ide-pnp.c | ||
| ide-probe.c | ||
| ide-proc.c | ||
| ide-tape.c | ||
| ide-taskfile.c | ||
| ide-timing.h | ||
| ide.c | ||
| Kconfig | ||
| Makefile | ||
| setup-pci.c | ||