mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-11-16 00:34:20 +08:00
26503ad25d
This prepares the btrtl code so it can be used to initialize Bluetooth modules connected via UART (these are found for example on the RTL8723BS and RTL8723DS SDIO chips, which come with an embedded UART Bluetooth module). The Realtek "rtl8723bs_bt" and "rtl8723ds_bt" userspace Bluetooth UART initialization tools (rtk_hciattach) use the following sequence: 1) send H5 sync pattern (already supported by hci_h5) 2) get LMP version (already supported by btrtl) 3) get ROM version (already supported by btrtl) 4) load the firmware and config for the current chipset (already supported by btrtl) 5) read UART settings from the config blob (currently not supported) 6) send UART settings via a vendor command to the device (which changes the baudrate of the device and enables or disables flow control depending on the config) 7) change the baudrate and flow control settings on the host 8) send the firmware and config blob to the device (already supported by btrtl) The main reason why the initialization has to be split is step #7. This requires changes to the underlying "bus", which should be kept outside of the "generic" btrtl driver. The idea for this split is borrowed from the btbcm driver but adjusted where needed (the btrtl driver for example needs two blobs: firmware and config, while the btbcm only needs one). This also prepares the code for step #5 (parsing the config blob) by centralizing the code which loads the firmware and config blobs and storing the result in the new struct btrtl_device_info. Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> Signed-off-by: Jeremy Cline <jeremy@jcline.org> Signed-off-by: Hans de Goede <hdegoede@redhat.com> Signed-off-by: Marcel Holtmann <marcel@holtmann.org> |
||
|---|---|---|
| .. | ||
| ath3k.c | ||
| bcm203x.c | ||
| bfusb.c | ||
| bluecard_cs.c | ||
| bpa10x.c | ||
| bt3c_cs.c | ||
| btbcm.c | ||
| btbcm.h | ||
| btintel.c | ||
| btintel.h | ||
| btmrvl_debugfs.c | ||
| btmrvl_drv.h | ||
| btmrvl_main.c | ||
| btmrvl_sdio.c | ||
| btmrvl_sdio.h | ||
| btqca.c | ||
| btqca.h | ||
| btqcomsmd.c | ||
| btrsi.c | ||
| btrtl.c | ||
| btrtl.h | ||
| btsdio.c | ||
| btusb.c | ||
| btwilink.c | ||
| dtl1_cs.c | ||
| h4_recv.h | ||
| hci_ag6xx.c | ||
| hci_ath.c | ||
| hci_bcm.c | ||
| hci_bcsp.c | ||
| hci_h4.c | ||
| hci_h5.c | ||
| hci_intel.c | ||
| hci_ldisc.c | ||
| hci_ll.c | ||
| hci_mrvl.c | ||
| hci_nokia.c | ||
| hci_qca.c | ||
| hci_serdev.c | ||
| hci_uart.h | ||
| hci_vhci.c | ||
| Kconfig | ||
| Makefile | ||