linux/drivers/media/rc
Matthias Reichl 0630efeee8 media: rc: ite-cir: lower timeout and extend allowed timeout range
The minimum possible timeout of ite-cir is 8 samples, which is
typically about 70us. The driver however changes the FIFO trigger
level from the hardware's default of 1 byte to 17 bytes, so the minimum
usable timeout value is 17 * 8 samples, which is typically about 1.2ms.

Tests showed that using timeouts down to 1.2ms actually work fine.

The current default timeout of 200ms is much longer than necessary and
the maximum timeout of 1s seems to have been chosen a bit arbitrarily.

So change the minimum timeout to the driver's limit of 17 * 8 samples
and bring timeout and maximum timeout in line with the settings
of many other receivers.

Signed-off-by: Matthias Reichl <hias@horus.com>
Signed-off-by: Sean Young <sean@mess.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab+samsung@kernel.org>
2018-05-14 07:17:28 -04:00
..
img-ir media: img-ir: Drop METAG dependency 2018-03-05 16:34:25 +00:00
keymaps MAINTAINERS & files: Canonize the e-mails I use at files 2018-05-04 06:21:06 -04:00
ati_remote.c [media] media: rc: constify usb_device_id 2017-10-04 15:06:09 -03:00
ene_ir.c media: rc: Convert timers to use timer_setup() 2017-10-31 06:31:44 -04:00
ene_ir.h [media] media: Drop FSF's postal address from the source code files 2017-01-27 11:38:09 -02:00
fintek-cir.c media: rc: rename RC_TYPE_* to RC_PROTO_* and RC_BIT_* to RC_PROTO_BIT_* 2017-08-20 10:02:48 -04:00
fintek-cir.h [media] media: Drop FSF's postal address from the source code files 2017-01-27 11:38:09 -02:00
gpio-ir-recv.c [media] media: rc: fix gpio-ir-receiver build failure 2017-10-05 10:16:21 -03:00
gpio-ir-tx.c media: rc: gpio-ir-tx: use ktime accessor functions 2017-08-31 05:35:54 -04:00
igorplugusb.c media: rc: Convert timers to use timer_setup() 2017-10-31 06:31:44 -04:00
iguanair.c media: rc: iguanair: simplify tx loop 2017-12-18 15:20:53 -05:00
imon_raw.c media: rc: new driver for early iMon device 2018-03-21 11:11:04 -04:00
imon.c media: imon: rename protocol from other to imon 2018-03-21 11:13:15 -04:00
ir-hix5hd2.c media: rc: ir-hix5hd2: fix error handling of clk_prepare_enable() 2018-02-14 13:35:05 -05:00
ir-imon-decoder.c media: rc: imon decoder: support the stick 2018-05-04 08:22:09 -04:00
ir-jvc-decoder.c media: rc: set timeout to smallest value required by enabled protocols 2018-04-20 09:14:31 -04:00
ir-mce_kbd-decoder.c media: rc: decoders do not need to check for transitions 2018-05-14 07:16:24 -04:00
ir-nec-decoder.c media: rc: set timeout to smallest value required by enabled protocols 2018-04-20 09:14:31 -04:00
ir-rc5-decoder.c media: rc: decoders do not need to check for transitions 2018-05-14 07:16:24 -04:00
ir-rc6-decoder.c media: rc: decoders do not need to check for transitions 2018-05-14 07:16:24 -04:00
ir-rx51.c [media] ir-rx51: port to rc-core 2017-01-30 14:25:04 -02:00
ir-sanyo-decoder.c media: rc: set timeout to smallest value required by enabled protocols 2018-04-20 09:14:31 -04:00
ir-sharp-decoder.c media: rc: set timeout to smallest value required by enabled protocols 2018-04-20 09:14:31 -04:00
ir-sony-decoder.c media: rc: set timeout to smallest value required by enabled protocols 2018-04-20 09:14:31 -04:00
ir-spi.c media: rc: ir-spi: update Andi's e-mail 2018-04-20 09:23:28 -04:00
ir-xmp-decoder.c media: rc: set timeout to smallest value required by enabled protocols 2018-04-20 09:14:31 -04:00
ite-cir.c media: rc: ite-cir: lower timeout and extend allowed timeout range 2018-05-14 07:17:28 -04:00
ite-cir.h media: rc: ite-cir: lower timeout and extend allowed timeout range 2018-05-14 07:17:28 -04:00
Kconfig media: rc: allow build pnp-dependent drivers with COMPILE_TEST 2018-05-04 09:47:45 -04:00
lirc_dev.c media: rc: per-protocol repeat period and minimum keyup timer 2018-04-20 09:16:55 -04:00
Makefile media: rc: add new imon protocol decoder and encoder 2018-03-21 11:12:29 -04:00
mceusb.c media: mceusb: add missing break 2018-05-14 07:12:33 -04:00
meson-ir.c media: rc: meson-ir: lower timeout and make configurable 2018-03-21 13:59:38 -04:00
mtk-cir.c media: rc: mtk-cir: use of_device_get_match_data() 2018-04-20 09:24:04 -04:00
nuvoton-cir.c media: rc: rename RC_TYPE_* to RC_PROTO_* and RC_BIT_* to RC_PROTO_BIT_* 2017-08-20 10:02:48 -04:00
nuvoton-cir.h media: rc: nuvoton: remove rudimentary transmit functionality 2017-08-20 09:47:57 -04:00
pwm-ir-tx.c media: rc: pwm-ir-tx: add new driver 2017-08-20 09:46:18 -04:00
rc-core-priv.h media: rc: imon decoder: support the stick 2018-05-04 08:22:09 -04:00
rc-ir-raw.c media: rc: drivers should produce alternate pulse and space timing events 2018-05-14 07:15:51 -04:00
rc-loopback.c media: rc: rename RC_TYPE_* to RC_PROTO_* and RC_BIT_* to RC_PROTO_BIT_* 2017-08-20 10:02:48 -04:00
rc-main.c media: rc: mce_kbd protocol encodes two scancodes 2018-04-20 09:18:33 -04:00
redrat3.c [media] media: rc: constify usb_device_id 2017-10-04 15:06:09 -03:00
serial_ir.c media: serial_ir: Convert timers to use timer_setup() 2017-10-27 17:38:54 +02:00
sir_ir.c media: rc: sir_ir: detect presence of port 2017-11-15 08:57:34 -05:00
st_rc.c media: st_rc: Don't stay on an IRQ handler forever 2018-04-17 05:50:05 -04:00
streamzap.c media: drivers: remove "/**" from non-kernel-doc comments 2017-11-30 04:19:03 -05:00
sunxi-cir.c media: rc: update sunxi-ir driver to get base clock frequency from devicetree 2018-03-21 11:08:33 -04:00
tango-ir.c media: rc: Add driver for tango HW IR decoder 2017-10-11 12:41:08 -04:00
ttusbir.c media: rc: rename RC_TYPE_* to RC_PROTO_* and RC_BIT_* to RC_PROTO_BIT_* 2017-08-20 10:02:48 -04:00
winbond-cir.c media: rc: winbond: do not send reset and timeout raw events on startup 2018-05-14 07:17:06 -04:00
zx-irdec.c media: rc: rename RC_TYPE_* to RC_PROTO_* and RC_BIT_* to RC_PROTO_BIT_* 2017-08-20 10:02:48 -04:00