mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-12-03 00:54:09 +08:00
0173f525b2
The MIPI DisCo device properties that are read by the driver from platform firmware, or hard-coded in the driver, should only be provided as sysfs entries when a driver probes successfully. However the device status and device number is updated even when there is no driver present, and hence can be updated when a Slave device is detected on the bus without being described in platform firmware and without any driver registered/probed. As suggested by GregKH, the attribute group for Slave status and device number is is added by default upon device registration. Credits to Vinod Koul for the status_show() function, shared in a separate patch and used as is here. The status table was modified to remove an unnecessary enum and status_show() is handled in a different group attribute than what was suggested by Vinod. Tested-by: Srinivas Kandgatla <srinivas.kandagatla@linaro.org> Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com> Co-developed-by: Vinod Koul <vkoul@kernel.org> Reviewed-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org> Link: https://lore.kernel.org/r/20200924194430.121058-3-pierre-louis.bossart@linux.intel.com Signed-off-by: Vinod Koul <vkoul@kernel.org> |
||
|---|---|---|
| .. | ||
| bus_type.c | ||
| bus.c | ||
| bus.h | ||
| cadence_master.c | ||
| cadence_master.h | ||
| debugfs.c | ||
| generic_bandwidth_allocation.c | ||
| intel_init.c | ||
| intel.c | ||
| intel.h | ||
| Kconfig | ||
| Makefile | ||
| master.c | ||
| mipi_disco.c | ||
| qcom.c | ||
| slave.c | ||
| stream.c | ||
| sysfs_local.h | ||
| sysfs_slave_dpn.c | ||
| sysfs_slave.c | ||