Change the logging of each algorithm from info level to debug level.
On the original devices supported by this code there were typically only
one or two algorithms in a firmware and one or two DSPs so this logging
only used a small number of log lines.
However, for the latest devices there could be 30-40 algorithms in a
firmware and 8 DSPs being loaded in parallel, so using 300+ lines of log
for information that isn't particularly important to have logged.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20230913160523.3701189-1-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Before adding a new FW control, its name is checked against
existing controls list. But the string length in strncmp used
to compare controls names is taken from the list, so if beginnings
of the controls are matching, then the new control is not created.
For example, if CAL_R control already exists, CAL_R_SELECTED
is not created.
The fix is to compare string lengths as well.
Fixes: 6477960755 ("ASoC: wm_adsp: Move check for control existence")
Signed-off-by: Vlad Karpovich <vkarpovi@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20230815172908.3454056-1-vkarpovi@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
In cs_dsp_load_coeff() region_name should be set in the XM/YM/ZM
cases otherwise any errors will log the region as "Unknown".
While doing this also change one error message that logged the
region type ID to log the region_name instead. This makes it
consistent with other messages in the same function.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20230605143238.4001982-1-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Change the message at the start of bin file loading from
cs_dsp_dbg() to cs_dsp_info() so that there is confirmation
in the kernel log that a bin file was loaded, and the name
of the file.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20230531170158.2744700-1-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The file named 'controls' in the DSP's debugfs root contains a
formatted table describing the controls defined within the loaded DSP
firmware, it is of the form
name: len region:offset addr fwname algid ctltype flags en dirty
Where flags is represented as a character for each flag if set, or '-',
enabled is whether the control is enabled or disabled and dirty is
whether the control value is set in the cache but not the hardware.
Signed-off-by: Simon Trimmer <simont@opensource.cirrus.com>
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20230328131018.6820-1-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
When a DSP can self-boot from ROM it is not necessary to download
firmware during the powering up sequence.
A DSP that required firmware download would fail in a previous
configuration step if firmware was not available.
Signed-off-by: Simon Trimmer <simont@opensource.cirrus.com>
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20230320112245.115720-4-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
There are devices containing Halo Core DSPs that self-boot, cs_dsp is
used to manage the running firmware but the host does not have direct
control over starting and stopping the DSP and so cs_dsp should consider
the DSP to be always running.
Signed-off-by: Simon Trimmer <simont@opensource.cirrus.com>
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20230320112245.115720-2-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Merge series from Richard Fitzgerald <rf@opensource.cirrus.com>:
Use EXPORT_SYMBOL_NS_GPL() instead of EXPORT_SYMBOL_GPL() and patch the
three drivers that use cs_dsp to add the MODULE_IMPORT_NS().
To make the namespace more specific the KConfig symbol for cs_dsp is
changed from CS_DSP to FW_CS_DSP.
Move all the exports into a namespace.
This also adds the MODULE_IMPORT_NS to the 3 drivers that use the
exported functions.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20221124134556.3343784-3-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Qualify the KConfig symbol for cs_dsp by adding a FW_ prefix so that
it is more explicit what is being referred to. This is preparation for
using the symbol to namespace the exports.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20221124134556.3343784-2-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
ALSA callers need to know whether there was a change to the value so
that they can report a control write change correctly.
Signed-off-by: Simon Trimmer <simont@opensource.cirrus.com>
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20221123165811.3014472-2-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Add helpers that can be layered on top of a buffer read from or to be
written to the DSP to faciliate accessing datastructures within the DSP
memory. These functions handle adding the padding bytes for the DSP,
converting to big endian, and packing arbitrary length data.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20220722094851.92521-2-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The code already has a post_stop callback, add a matching pre_stop
callback to the client_ops that is called before execution is stopped.
This callback provides a convenient place for the client code to
communicate with the DSP before it is stopped.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20220722094851.92521-1-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
For wmfw format v2 and later the coefficient name strings have a length
field and are NOT null-terminated. Use kasprintf() to convert the
unterminated string into a null-terminated string in an allocated buffer.
The previous code handled this duplication incorrectly using kmemdup()
and getting the length from a strlen() of the (unterminated) source string.
This resulted in creating a string that continued up to the next byte in
the firmware file that just happened to be 0x00.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Fixes: f6bc909e76 ("firmware: cs_dsp: add driver to support firmware loading on Cirrus Logic DSPs")
Link: https://lore.kernel.org/r/20220412163927.1303470-1-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
If the Halo registers are kept in the register cache the
HALO_CORE_RESET bit will be retained as 1 after reset is triggered in
cs_dsp_halo_start_core. This will cause subsequent writes to reset
the core which is not desired. Apart from this bit the rest of the
register bits are cacheable, so for safety sake clear the bit to
ensure the cache is consistent.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20220105113026.18955-6-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Move the lockdep asserts until after the ctl pointer has been checked
for NULL, to avoid potentially NULL pointer dereferences.
Fixes: fb2f364fb5b9 ("firmware: cs_dsp: Add lockdep asserts to interface functions")
Reported-by: kernel test robot <lkp@intel.com>
Reported-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211130102842.26410-1-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Some firmwares contain controls intended to convey firmware state back
to the host. Whilst more infrastructure will probably be needed for
these in time, as a first step allow creation of the controls, so said
firmwares arn't completely rejected.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211117132300.1290-10-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Add a NULL check to the cs_dsp_coeff_write/read_ctrl functions. This is
a major convenience for users of the cs_dsp library as it allows the call
to cs_dsp_get_ctl to be inlined with the call to read/write the control
itself.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211117132300.1290-7-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Add support for the revision 2 coefficient file, this format is
identical to revision 1 and was simply added by accident to some
firmware. However unfortunately many firmwares have leaked into
production using this and as such driver support really needs to
be added for it.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211117132300.1290-6-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The coefficient file contains various info strings, and the equivalent
strings are printed from the WMFW file as it is loaded. Add support
for printing these from the coefficient file as well.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211117132300.1290-5-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The code already has a post_run callback, add a matching pre_run
callback to the client_ops that is called before execution is started.
This callback provides a convenient place for the client code to
set DSP controls or hardware that requires configuration before
the DSP core actually starts execution. Note that placing this callback
before cs_dsp_coeff_sync_controls is important to ensure that any
control values are then correctly synced out to the chip.
Co-authored-by: Simon Trimmer <simont@opensource.cirrus.com>
Signed-off-by: Simon Trimmer <simont@opensource.cirrus.com>
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211117132300.1290-4-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The firmware coefficient files contain version information that is
currently ignored by the cs_dsp code. This information specifies which
version of the firmware the coefficient were generated for. Add a check
into the code which prints a warning in the case the coefficient and
firmware differ in version, in many cases this will be ok but it is not
always, so best to let the user know there is a potential issue.
Co-authored-by: Simon Trimmer <simont@opensource.cirrus.com>
Signed-off-by: Simon Trimmer <simont@opensource.cirrus.com>
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211117132300.1290-3-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Some of the control functions exposed by the cs_dsp code require the
pwr_lock to be held by the caller. Add lockdep_assert_held calls to
ensure this is done correctly.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211117132300.1290-2-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch removes unused included header files and moves others into
cs_dsp.h to ensure that types referenced in the header file are properly
described to prevent compiler warnings.
Signed-off-by: Simon Trimmer <simont@opensource.cirrus.com>
Acked-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211115120215.56824-1-simont@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
wm_adsp originally provided firmware loading on some audio DSP and was
implemented as an ASoC codec driver. However, the firmware loading now
covers a wider range of DSP cores and peripherals containing them,
beyond just audio. So it needs to be available to non-audio drivers. All
the core firmware loading support has been moved into a new driver
cs_dsp, leaving only the ASoC-specific parts in wm_adsp.
Signed-off-by: Simon Trimmer <simont@opensource.cirrus.com>
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20210913160057.103842-17-simont@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
