We should get 'driver_data' from 'struct device' directly. Going via
platform_device is an unneeded step back and forth.
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Reviewed-by: Simon Horman <horms+renesas@verge.net.au>
Reviewed-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Signed-off-by: Eduardo Valentin <edubezval@gmail.com>
Adding brackets allows to multiply the register value,
masked by TS1_RAMP_COEFF_MASK, by an ADJUST value
properly and not to multiply ADJUST by register value and
then mask the whole.
Fixes: 1d693155 ("thermal: add stm32 thermal driver")
Reviewed-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Signed-off-by: David Hernandez Sanchez <david.hernandezsanchez@st.com>
Signed-off-by: Eduardo Valentin <edubezval@gmail.com>
Calling stm_thermal_read_factory_settings before clocking
internal peripheral causes bad register values and makes
temperature computation wrong.
Calling stm_thermal_read_factory_settings inside
stm_thermal_prepare fixes this problem as internal
peripheral is well clocked at this stage.
Fixes: 1d693155 ("thermal: add stm32 thermal driver")
Reviewed-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Signed-off-by: David Hernandez Sanchez <david.hernandezsanchez@st.com>
Signed-off-by: Eduardo Valentin <edubezval@gmail.com>
Add support for DTS thermal sensor that can be
found on some STM32 platforms.
This driver is based on OF and works in interrupt
mode.
It offers two temperature trip points:
passive and critical. The first is intended for
passive cooling notification while the second is
used for over-temperature reset.
Signed-off-by: David Hernandez Sanchez <david.hernandezsanchez@st.com>
Signed-off-by: Eduardo Valentin <edubezval@gmail.com>
