After commit b8a1a4cd5a ("i2c: Provide a temporary .probe_new()
call-back type"), all drivers being converted to .probe_new() and then
03c835f498 ("i2c: Switch .probe() to not take an id parameter")
convert back to (the new) .probe() to be able to eventually drop
.probe_new() from struct i2c_driver.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
The connector child node of the TUSB320 device might be linked with a
dual-role capable USB controller. Add driver support for detecting a
usb_role_switch and setting its state in the typec interrupt handler.
This follows similar practice in other drivers in the typec subsystem,
which this extcon driver can opt-in to.
Signed-off-by: Alvin Šipraga <alsi@bang-olufsen.dk>
Acked-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
The TUSB320 can detect the following types of accessory:
- Audio Accessory
- Audio Accessory with charge-thru
- Debug Accessory (DFP)
- Debug Accessory (UFP)
Moreover, the typec subsystem can be informed of this through the
typec_set_mode() function. The information will be propagated to any
linked typec muxes. Add the necessary support to the driver.
Note that for the Debug Accessory modes, an educated guess was made that
for the USB data role, DFP implies HOST and UFP implies DEVICE. But this
might want to be made configurable at a later date.
Signed-off-by: Alvin Šipraga <alsi@bang-olufsen.dk>
Acked-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
The driver can register a typec port if suitable firmware properties are
present. But if the driver is removed through sysfs unbind, rmmod or
similar, then it does not clean up after itself and the typec port
device remains registered. This can be seen in sysfs, where stale typec
ports get left over in /sys/class/typec.
In order to fix this we have to add an i2c_driver remove function and
call typec_unregister_port(), which is a no-op in the case where no
typec port is created and the pointer remains NULL.
In the process we should also put the fwnode_handle when the typec port
isn't registered anymore, including if an error occurs during probe. The
typec subsystem does not increase or decrease the reference counter for
us, so we track it in the driver's private data.
Note that the conditional check on TYPEC_PWR_MODE_PD was removed in the
probe path because a call to tusb320_set_adv_pwr_mode() will perform an
even more robust validation immediately after, hence there is no
functional change here.
Fixes: bf7571c00d ("extcon: usbc-tusb320: Add USB TYPE-C support")
Cc: stable@vger.kernel.org
Signed-off-by: Alvin Šipraga <alsi@bang-olufsen.dk>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
Here is the large set of char/misc and other driver subsystem changes
for 6.2-rc1. Nothing earth-shattering in here at all, just a lot of new
driver development and minor fixes. Highlights include:
- fastrpc driver updates
- iio new drivers and updates
- habanalabs driver updates for new hardware and features
- slimbus driver updates
- speakup module parameters added to aid in boot time configuration
- i2c probe_new conversions for lots of different drivers
- other small driver fixes and additions
One semi-interesting change in here is the increase of the number of
misc dynamic minors available to 1048448 to handle new huge-cpu systems.
All of these have been in linux-next for a while with no reported
problems.
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
-----BEGIN PGP SIGNATURE-----
iG0EABECAC0WIQT0tgzFv3jCIUoxPcsxR9QN2y37KQUCY5wrdw8cZ3JlZ0Brcm9h
aC5jb20ACgkQMUfUDdst+ykSDgCdHjUHS62/UnKdB9rLtyAOFxS/6DgAn2X4Unf8
RN8Mn2mUIiBzyu5p+Zc7
=tK3S
-----END PGP SIGNATURE-----
Merge tag 'char-misc-6.2-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc
Pull char/misc driver updates from Greg KH:
"Here is the large set of char/misc and other driver subsystem changes
for 6.2-rc1. Nothing earth-shattering in here at all, just a lot of
new driver development and minor fixes.
Highlights include:
- fastrpc driver updates
- iio new drivers and updates
- habanalabs driver updates for new hardware and features
- slimbus driver updates
- speakup module parameters added to aid in boot time configuration
- i2c probe_new conversions for lots of different drivers
- other small driver fixes and additions
One semi-interesting change in here is the increase of the number of
misc dynamic minors available to 1048448 to handle new huge-cpu
systems.
All of these have been in linux-next for a while with no reported
problems"
* tag 'char-misc-6.2-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc: (521 commits)
extcon: usbc-tusb320: Convert to i2c's .probe_new()
extcon: rt8973: Convert to i2c's .probe_new()
extcon: fsa9480: Convert to i2c's .probe_new()
extcon: max77843: Replace irqchip mask_invert with unmask_base
chardev: fix error handling in cdev_device_add()
mcb: mcb-parse: fix error handing in chameleon_parse_gdd()
drivers: mcb: fix resource leak in mcb_probe()
coresight: etm4x: fix repeated words in comments
coresight: cti: Fix null pointer error on CTI init before ETM
coresight: trbe: remove cpuhp instance node before remove cpuhp state
counter: stm32-lptimer-cnt: fix the check on arr and cmp registers update
misc: fastrpc: Add dma_mask to fastrpc_channel_ctx
misc: fastrpc: Add mmap request assigning for static PD pool
misc: fastrpc: Safekeep mmaps on interrupted invoke
misc: fastrpc: Add support for audiopd
misc: fastrpc: Rework fastrpc_req_munmap
misc: fastrpc: Use fastrpc_map_put in fastrpc_map_create on fail
misc: fastrpc: Add fastrpc_remote_heap_alloc
misc: fastrpc: Add reserved mem support
misc: fastrpc: Rename audio protection domain to root
...
The probe function doesn't make use of the i2c_device_id * parameter so it
can be trivially converted.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
Currently this driver triggers extcon and typec state update in its
probe function, to read out current state reported by the chip and
report the correct state to upper layers. This synchronization is
performed correctly, but only in case the chip indicates a pending
interrupt in reg09 register.
This fails to cover the situation where all interrupts reported by
the chip were already handled by Linux before reboot, then the system
rebooted, and then Linux starts again. In this case, the TUSB320 no
longer reports any interrupts in reg09, and the state update does not
perform any update as it depends on that interrupt indication.
Fix this by turning tusb320_irq_handler() into a thin wrapper around
tusb320_state_update_handler(), where the later now contains the bulk
of the code of tusb320_irq_handler(), but adds new function parameter
"force_update". The "force_update" parameter can be used by the probe
function to assure that the state synchronization is always performed,
independent of the interrupt indicated in reg09. The interrupt handler
tusb320_irq_handler() callback uses force_update=false to avoid state
updates on potential spurious interrupts and retain current behavior.
Fixes: 06bc4ca115 ("extcon: Add driver for TI TUSB320")
Signed-off-by: Marek Vasut <marex@denx.de>
Reviewed-by: Alvin Šipraga <alsi@bang-olufsen.dk>
Acked-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Link: https://lore.kernel.org/r/20221120141509.81012-1-marex@denx.de
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Commit bf7571c00d ("extcon: usbc-tusb320: Add USB TYPE-C support")
added an optional Type-C interface to the driver but missed to check
if it is in use when calling the IRQ handler. This causes an oops on
devices currently using the old extcon interface. Check if a Type-C
port is registered before calling the Type-C IRQ handler.
Fixes: bf7571c00d ("extcon: usbc-tusb320: Add USB TYPE-C support")
Signed-off-by: Yassine Oudjana <y.oudjana@protonmail.com>
Reviewed-by: Marek Vasut <marex@denx.de>
Reviewed-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Link: https://lore.kernel.org/r/20221107153317.657803-1-y.oudjana@protonmail.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Fix the warning:
drivers/extcon/extcon-usbc-tusb320.c:19: warning: expecting prototype
for drivers/extcon/extcon-tusb320.c(). Prototype was for TUSB320_REG8()
instead
Reported-by: kernel test robot <lkp@intel.com>
Signed-off-by: Rong Chen <rong.a.chen@intel.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
The TI TUSB320 seems like a better fit for USB TYPE-C subsystem,
which can expose details collected by the TUSB320 in a far more
precise way than extcon. Since there are existing users in the
kernel and in DT which depend on the extcon interface, keep it
for now.
Add TYPE-C interface and expose the supported supply current,
direction and connector polarity via the TYPE-C interface.
Signed-off-by: Marek Vasut <marex@denx.de>
Acked-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Reviewed-by: Alvin Šipraga <alsi@bang-olufsen.dk>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
Move extcon code into separate functions in preparation for addition of
USB TYPE-C support. No functional change.
Signed-off-by: Marek Vasut <marex@denx.de>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
TUSB320L is a newer chip with additional features, and it has additional steps
in its mode changing sequence:
- Disable CC state machine,
- Write to mode register,
- Wait for 5 ms,
- Re-enable CC state machine.
It also has an additional register that a revision number can be read from.
Add support for the mode changing sequence, and read the revision number during
probe and print it as info.
Signed-off-by: Yassine Oudjana <y.oudjana@protonmail.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
Reset the chip and set its mode to default (maintain mode set by PORT pin)
during probe to make sure it comes up in the default state.
Signed-off-by: Yassine Oudjana <y.oudjana@protonmail.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
This patch adds an extcon driver for the TI TUSB320 USB Type-C device.
This can be used to detect whether the port is configured as a
downstream or upstream facing port.
Signed-off-by: Michael Auchter <michael.auchter@ni.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
