If there are two flash chips connected flash regions can refer to the
second chip too. In this case we may see the following warning:
mtd: partition "BIOS" extends beyond the end of device "0000:00:1f.5" --
size truncated to 0x400000
For this reason, check the BIOS partition size against the chip size and
make sure it stays within the that.
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Link: https://lore.kernel.org/r/20240201121638.207632-2-mika.westerberg@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Instead of comparing parameters for every supported mem_ops, only compare
on opcode match, which is relatively more efficient.
Signed-off-by: Raag Jadav <raag.jadav@intel.com>
Reviewed-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Link: https://lore.kernel.org/r/20231117144053.24005-1-raag.jadav@intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Supporting multi-cs in spi drivers would require the chip_select & cs_gpiod
members of struct spi_device to be an array. But changing the type of these
members to array would break the spi driver functionality. To make the
transition smoother introduced four new APIs to get/set the
spi->chip_select & spi->cs_gpiod and replaced all spi->chip_select and
spi->cs_gpiod references with get or set API calls.
While adding multi-cs support in further patches the chip_select & cs_gpiod
members of the spi_device structure would be converted to arrays & the
"idx" parameter of the APIs would be used as array index i.e.,
spi->chip_select[idx] & spi->cs_gpiod[idx] respectively.
Signed-off-by: Amit Kumar Mahapatra <amit.kumar-mahapatra@amd.com>
Acked-by: Heiko Stuebner <heiko@sntech.de> # Rockchip drivers
Reviewed-by: Michal Simek <michal.simek@amd.com>
Reviewed-by: Cédric Le Goater <clg@kaod.org> # Aspeed driver
Reviewed-by: Dhruva Gole <d-gole@ti.com> # SPI Cadence QSPI
Reviewed-by: Patrice Chotard <patrice.chotard@foss.st.com> # spi-stm32-qspi
Acked-by: William Zhang <william.zhang@broadcom.com> # bcm63xx-hsspi driver
Reviewed-by: Serge Semin <fancer.lancer@gmail.com> # DW SSI part
Link: https://lore.kernel.org/r/167847070432.26.15076794204368669839@mailman-core.alsa-project.org
Signed-off-by: Mark Brown <broonie@kernel.org>
The flash decriptor contains the number of flash components that we use
to figure out how many flash chips there are connected. Therefore we
need to read it first before deciding how many chip selects the
controller has.
Reported-by: Marcin Witkowski <marcin.witkowski@intel.com>
Fixes: 3f03c618be ("spi: intel: Add support for second flash chip")
Cc: stable@vger.kernel.org
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Link: https://lore.kernel.org/r/20230215110040.42186-1-mika.westerberg@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Some private data fields have to change from bxt_info to cnl_info.
Here is the list of Device IDs with the respective documentation taken for
validation:
0xa0a4 - Intel® 500 Series Chipset Family On-Package PCH
0x02a4 - Intel® 400 Series Chipset Family On-Package PCH
0x06a4 - Intel® 400 Series Chipset Family Platform Controller Hub
0x34a4 - Intel® 495 Chipset Family On-Package
0xa3a4 - Intel® B460 and H410 Chipset
According to documentation Broxton controller type has five PR registers.
Signed-off-by: Mauro Lima <mauro.lima@eclypsium.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Link: https://lore.kernel.org/r/20230201205455.550308-2-mauro.lima@eclypsium.com
Signed-off-by: Mark Brown <broonie@kernel.org>
A busy enough release, but not for the core which has only seen very
small updates. The biggest addition is the readdition of support for
detailed configuration of the timings around chip selects. That had
been removed for lack of use but there's been applications found for it
on Atmel systems. Otherwise the updates are mostly feature additions
and cleanups to existing drivers.
- Provide a helper for getting device match data in a way that
abstracts away which firmware interface is being used.
- Re-add the spi_set_cs_timing() API for detailed configuration of the
timing around chip select and support it on Atmel.
- Support for MediaTek MT7986, Microchip PCI1xxxx, Nuvoton WPCM450 FIU
and Socionext F_OSPI.
There's a straightforward add/add conflict with the rpmsg tree in the
xilinx firmware code (both trees got new users of the firmware added
each needing new firmware<->kernel ioctls).
There's a cross tree merge with I2C in order to use the new
i2c_client_get_device_id() helper in some I2C attached SPI controllers
as part of their conversion to I2C's probe_new() API.
-----BEGIN PGP SIGNATURE-----
iQEzBAABCgAdFiEEreZoqmdXGLWf4p/qJNaLcl1Uh9AFAmOXIt8ACgkQJNaLcl1U
h9Alrwf9F6mgj3eaDbhPH2lJ+zZRDJrdrMxT1US1tWixCMEZilntDXVecJA+/htp
/tJ0InGXsyr+6p9lXsFGQZGuaSIzKh0h2OW3JCakPGfp6HvA8+qXqHYSLKzIXtYU
/lk+kR+H6TGG+pjFtwkNnbCY/pYAlOtdjdmfui68VSsqWYX1W1kJDhDEkpUZePUx
Bc9wGgGByL0ZEHMQ/O6d8Nc/JzfTQPFuPB9ZHpIHFuPuAnjDQx+veaWejpVawy+D
8crMM7OgGpHy1hENSN786039QvNbWvVucPyVwJfU4SDhrT6oNNmEA/RF/DqTt472
8cbNG5H5bSR0Youv9ofxdP9bAOHhtg==
=eJDv
-----END PGP SIGNATURE-----
Merge tag 'spi-v6.2' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi
Pull spi updates from Mark Brown:
"A busy enough release, but not for the core which has only seen very
small updates. The biggest addition is the readdition of support for
detailed configuration of the timings around chip selects. That had
been removed for lack of use but there's been applications found for
it on Atmel systems. Otherwise the updates are mostly feature
additions and cleanups to existing drivers.
Summary:
- Provide a helper for getting device match data in a way that
abstracts away which firmware interface is being used.
- Re-add the spi_set_cs_timing() API for detailed configuration of
the timing around chip select and support it on Atmel.
- Support for MediaTek MT7986, Microchip PCI1xxxx, Nuvoton WPCM450
FIU and Socionext F_OSPI"
* tag 'spi-v6.2' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi: (66 commits)
spi: dt-bindings: Convert Synquacer SPI to DT schema
spi: spi-gpio: Don't set MOSI as an input if not 3WIRE mode
spi: spi-mtk-nor: Add recovery mechanism for dma read timeout
spi: spi-fsl-lpspi: add num-cs binding for lpspi
spi: spi-fsl-lpspi: support multiple cs for lpspi
spi: mtk-snfi: Add snfi support for MT7986 IC
spi: spidev: mask SPI_CS_HIGH in SPI_IOC_RD_MODE
spi: cadence-quadspi: Add minimum operable clock rate warning to baudrate divisor calculation
spi: microchip: pci1xxxx: Add suspend and resume support for PCI1XXXX SPI driver
spi: dt-bindings: nuvoton,wpcm450-fiu: Fix warning in example (missing reg property)
spi: dt-bindings: nuvoton,wpcm450-fiu: Fix error in example (bogus include)
spi: mediatek: Enable irq when pdata is ready
spi: spi-mtk-nor: Unify write buffer on/off
spi: intel: Add support for SFDP opcode
spi: intel: Take possible chip address into account in intel_spi_read/write_reg()
spi: intel: Implement adjust_op_size()
spi: intel: Use ->replacement_op in intel_spi_hw_cycle()
spi: cadence: Drop obsolete dependency on COMPILE_TEST
spi: Add Nuvoton WPCM450 Flash Interface Unit (FIU) bindings
spi: wpcm-fiu: Add direct map support
...
The Intel SPI-NOR controller supports SFDP (Serial Flash Discoverable
Parameter) opcode so add it to the list of supported opcodes.
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Link: https://lore.kernel.org/r/20221025064623.22808-5-mika.westerberg@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
This allows us to get rid of the checks in the intel_spi_[sh]w_cycle()
and makes it possible for the SPI-NOR core to split the transaction into
smaller chunks as needed.
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Link: https://lore.kernel.org/r/20221025064623.22808-3-mika.westerberg@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
According to documentation, the 64K erase opcode is located in VSCC
range [16:23] instead of [8:15].
Use the proper value to shift the mask over the correct range.
Signed-off-by: Mauro Lima <mauro.lima@eclypsium.com>
Reviewed-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Link: https://lore.kernel.org/r/20221012152135.28353-1-mauro.lima@eclypsium.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The hardware sequencer in Intel Canon Lake and beyond supports also 64k
erase command. The SPI-NOR core uses SFDP (Serial Flash Discovery
Parameter) to figure out what the chip actually supports and only issues
64k erase if it is supported.
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Link: https://lore.kernel.org/r/20220816125537.89389-1-mika.westerberg@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Intel SPI flash controller has been supporting two chip selects long
time already even if the most common configuration is to have a single
flash chip for the BIOS and related data. This adds support for the
second chip select if we find out that there are two flash components
(this information is available in the mandatory flash descriptor on the
first chip). The second chip is exposed as is without any partition
information.
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Link: https://lore.kernel.org/r/20220816130818.89600-1-mika.westerberg@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Currently the driver goes over the supported opcodes list each time
->exec_op() is called and finds the suitable for the given operation.
This consumes unnecessary amount of CPU cycles because the operation is
always the same. For this reason populate dirmap hooks for the driver so
that we cache the selected operation and then simply call it on each
read/write.
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Link: https://lore.kernel.org/r/20220420104350.19510-1-mika.westerberg@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The preferred way to implement SPI-NOR controller drivers is through SPI
subsubsystem utilizing the SPI MEM core functions. This converts the
Intel SPI flash controller driver over the SPI MEM by moving the driver
from SPI-NOR subsystem to SPI subsystem and in one go make it use the
SPI MEM functions. The driver name will be changed from intel-spi to
spi-intel to match the convention used in the SPI subsystem.
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Reviewed-by: Mauro Lima <mauro.lima@eclypsium.com>
Reviewed-by: Boris Brezillon <boris.brezillon@collabora.com>
Acked-by: Lee Jones <lee.jones@linaro.org>
Acked-by: Pratyush Yadav <p.yadav@ti.com>
Reviewed-by: Tudor Ambarus <tudor.ambarus@microchip.com>
Link: https://lore.kernel.org/r/20220209122706.42439-3-mika.westerberg@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
