This patch adds a new flag, MIPI_DSI-MODE_LPM, to transmit data
in low power. With this flag, msg.flags has MIPI_DSI_MSG_USE_LPM
so that host driver of each SoC can clear or set relevant register
bit for low power transmission.
All host drivers shall support continuous clock behavior on the
Clock Lane, and optionally may support non-continuous clock behavior.
Both of them can transmit data in high speed of low power.
With each clock behavior, non-continuous or continuous clock mode,
host controller will transmit data in high speed by default so if
peripheral wants to receive data in low power, the peripheral driver
should set MIPI_DSI_MODE_LPM flag.
Signed-off-by: Inki Dae <inki.dae@samsung.com>
When executing DCS commands, use the channel associated with the DSI
peripheral rather than one explicitly specified in the function call.
Devices shouldn't be able to step on each others' toes like this.
Acked-by: Andrzej Hajda <a.hajda@samsung.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
This function returns the value of the struct mipi_dsi_host_ops'
.transfer() so make sure the return types are consistent.
Acked-by: Andrzej Hajda <a.hajda@samsung.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
As per section 5.6.1 of the DSI specification, all DSI transmitters must
support continuous clock behavior on the clock lane, while non-continuous
mode support is only optional. Add a flag that allows devices to indicate
that they support non-continuous clock mode so host drivers can adapt
their behavior accordingly.
Signed-off-by: Alexandre Courbot <acourbot@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
Hook up the MIPI DSI bus's .shutdown() function to allow drivers to
implement code that should be run when a device is shut down.
Signed-off-by: Thierry Reding <treding@nvidia.com>
This patch adds flags field to mipi_dsi_msg structure and two flags:
- MIPI_DSI_MSG_REQ_ACK - request ACK from peripheral for given message,
- MIPI_DSI_MSG_USE_LPM - use Low Power Mode to transmit message.
The first flag is usually helpful during DSI diagnostic, the second
flag is required by some peripherals during configuration phase.
Signed-off-by: Andrzej Hajda <a.hajda@samsung.com>
Signed-off-by: Inki Dae <inki.dae@samsung.com>
MIPI DSI bus allows to model DSI hosts and DSI peripherals using the
Linux driver model. DSI hosts are registered by the DSI host drivers.
During registration DSI peripherals will be created from the children
of the DSI host's device tree node. Support for registration from
board-setup code will be added later when needed.
DSI hosts expose operations which can be used by DSI peripheral drivers
to access associated devices.
Signed-off-by: Andrzej Hajda <a.hajda@samsung.com>
Signed-off-by: Kyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
