Propagate sNaN payload in quieting in the legacy-NaN mode as well. If
clearing the quiet bit would produce infinity, then set the next lower
trailing significand field bit, matching the SB-1 and BMIPS5000 hardware
implementations. Some other MIPS FPU hardware implementations do
produce the default qNaN bit pattern instead.
This reverts some changes made for semantics preservation with commit
dc3ddf42 [MIPS: math-emu: Update sNaN quieting handlers], consequently
bringing back most of the semantics from before commit fdffbafb [Lots of
FPU bug fixes from Kjeld Borch Egevang.], except from the qNaN produced
in the infinity case. Previously the default qNaN bit pattern was
produced in that case.
Signed-off-by: Maciej W. Rozycki <macro@imgtec.com>
Cc: Andrew Morton <akpm@linux-foundation.org>
Cc: Matthew Fortune <Matthew.Fortune@imgtec.com>
Cc: linux-mips@linux-mips.org
Cc: linux-kernel@vger.kernel.org
Patchwork: https://patchwork.linux-mips.org/patch/11483/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Implement IEEE Std 754-2008 NaN encoding wired to the state of the
FCSR.NAN2008 bit. Make the interpretation of the quiet bit in NaN data
as follows:
* in the legacy mode originally defined by the MIPS architecture the
value of 1 denotes an sNaN whereas the value of 0 denotes a qNaN,
* in the 2008 mode introduced with revision 5 of the MIPS architecture
the value of 0 denotes an sNaN whereas the value of 1 denotes a qNaN,
following the definition of the preferred NaN encoding introduced with
IEEE Std 754-2008.
In the 2008 mode, following the requirement of the said standard, quiet
an sNaN where needed by setting the quiet bit to 1 and leaving all the
NaN payload bits unchanged.
Update format conversion operations according to the rules set by IEEE
Std 754-2008 and the MIPS architecture. Specifically:
* propagate NaN payload bits through conversions between floating-point
formats such that as much information as possible is preserved and
specifically a conversion from a narrower format to a wider format and
then back to the original format does not change a qNaN payload in any
way,
* conversions from a floating-point to an integer format where the
source is a NaN, infinity or a value that would convert to an integer
outside the range of the result format produce, under the default
exception handling, the respective values defined by the MIPS
architecture.
In full FPU emulation set the FIR.HAS2008 bit to 1, however do not make
any further FCSR bits writable.
Signed-off-by: Maciej W. Rozycki <macro@imgtec.com>
Cc: Andrew Morton <akpm@linux-foundation.org>
Cc: Matthew Fortune <Matthew.Fortune@imgtec.com>
Cc: linux-mips@linux-mips.org
Cc: linux-kernel@vger.kernel.org
Patchwork: https://patchwork.linux-mips.org/patch/11477/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
The `ieee754sp_isnan' and `ieee754dp_isnan' NaN classifiers are now no
longer externally referred, remove their header prototypes and make them
local to the two only respective places still making use of them.
Signed-off-by: Maciej W. Rozycki <macro@linux-mips.org>
Cc: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/9693/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
We have the input operands already classified in `ieee754sp_cmp' and
`ieee754dp_cmp' comparison operations, so use the class obtained to tell
NaNs and numbers apart rather than classifying inputs again for this
purpose, reducing the size of code by 24 and 40 instructions or 96 and
160 bytes respectively.
Signed-off-by: Maciej W. Rozycki <macro@linux-mips.org>
Cc: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/9689/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Revert the changes made by commit fdffbafb [Lots of FPU bug fixes from
Kjeld Borch Egevang.] to `ieee754sp_nanxcpt' and `ieee754dp_nanxcpt'
sNaN quieting handlers and their callers so that sNaN processing is done
within the handlers againg. Pass the sNaN causing an IEEE 754 invalid
operation exception down to the relevant handler. Pass the sNaN in `fs'
where two sNaNs are supplied to a binary operation.
Set the Invalid Operation FCSR exception bits in the quieting handlers
rather than at their call sites throughout. Make the handlers exclusive
for sNaN processing.
Signed-off-by: Maciej W. Rozycki <macro@linux-mips.org>
Cc: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/9688/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Commit fdffbafb [Lots of FPU bug fixes from Kjeld Borch Egevang.]
replaced the two single `ieee754sp_nanxcpt' and `ieee754dp_nanxcpt'
places, where sNaN quieting used to happen for single and double
floating-point operations respectively, with individual qNaN
instantiations across all the call sites instead. It also made most of
these two functions dead code as where called on a qNaN they return
right away.
To revert the damage and make sNaN quieting uniform again first rewrite
`ieee754sp_nanxcpt' and `ieee754dp_nanxcpt' to do the same quieting all
the call sites do, that is return the default qNaN encoding for all
input sNaN values; never propagate any sNaN payload bits from its
trailing significand field.
Signed-off-by: Maciej W. Rozycki <macro@linux-mips.org>
Cc: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/9685/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Based on the spatch
@@
expression e;
@@
- return (e);
+ return e;
with heavy hand editing because some of the changes are either whitespace
or identation only or result in excessivly long lines.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Previously math-emu was using the IEEE-754 constants internally. These
were differing by having the constants for rounding to +/- infinity
switched, so a conversion was necessary. This would be entirely
avoidable if the MIPS constants were used throughout, so get rid of
the bloat.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
o Only define variables in the outermost block
o One empty line at most
o Format comments as per CodingStyle
o Update FSF address in licensing term comment
o Spell FPU and MIPS in all capitals.
o Remove ####-type of lines in comments.
o Try to make things a bit most consistent between sp_*.c / dp_*.c files.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
There are two version of get_rounding(), one for single precision, one
for double precision. Add a ieee754sp_ rsp. ieee754dp_ prefix for
clarity.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Both are unused since lmo commit fdffbafbb38723618626c70ffdc6ff9175cdffa2
[Lots of FPU bug fixes from Kjeld Borch Egevang.]
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Having received another series of whitespace patches I decided to do this
once and for all rather than dealing with this kind of patches trickling
in forever.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
The patch below updates broken web addresses in the arch directory.
Signed-off-by: Justin P. Mattock <justinmattock@gmail.com>
Signed-off-by: Maciej W. Rozycki <macro@linux-mips.org>
Cc: Finn Thain <fthain@telegraphics.com.au>
Cc: Randy Dunlap <rdunlap@xenotime.net>
Reviewed-by: Finn Thain <fthain@telegraphics.com.au>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Signed-off-by: Roel Kluin <roel.kluin@gmail.com>
To: linux-mips@linux-mips.org
To: Andrew Morton <akpm@linux-foundation.org>
To: LKML <linux-kernel@vger.kernel.org>
Patchwork: http://patchwork.linux-mips.org/patch/860/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
