Add a timestamping mechanism for buffer that provides accurate
event timestamps when using watermark. This mechanism estimates
device internal clock by comparing FIFO interrupts delta time and
device elapsed time computed by parsing FIFO data.
Take interrupt timestamp in hard irq handler and add IIO device
specific timestamp structures in device private allocation.
Signed-off-by: Jean-Baptiste Maneyrol <jmaneyrol@invensense.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Add all FIFO parsing and reading functions. Add accel and gyro
kfifo buffer and FIFO data parsing. Use device interrupt for
reading data FIFO and launching accel and gyro parsing.
Support hwfifo watermark by multiplexing gyro and accel settings.
Support hwfifo flush.
Signed-off-by: Jean-Baptiste Maneyrol <jmaneyrol@invensense.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Add INT1 interrupt support. Support interrupt edge and level,
active high or low. Push-pull or open-drain configurations.
Interrupt will be used to read data from the FIFO.
Signed-off-by: Jean-Baptiste Maneyrol <jmaneyrol@invensense.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Add temperature channel in gyroscope and accelerometer devices.
Temperature is available in full 16 bits resolution when reading
register and in low 8 bits resolution in the FIFO. Return full
precision raw temperature with corresponding scale and offset.
Signed-off-by: Jean-Baptiste Maneyrol <jmaneyrol@invensense.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Add SPI driver for InvenSense ICM-426xxx devices.
Configure bus signal slew rates as indicated in the datasheet.
Signed-off-by: Jean-Baptiste Maneyrol <jmaneyrol@invensense.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Add I2C driver for InvenSense ICM-426xxx devices.
Configure bus signal slew rates as indicated in the datasheet.
Signed-off-by: Jean-Baptiste Maneyrol <jmaneyrol@invensense.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Core component of a new driver for InvenSense ICM-426xx devices.
It includes registers definition, main probe/setup, and device
utility functions.
ICM-426xx devices are latest generation of 6-axis IMU,
gyroscope+accelerometer and temperature sensor. This device
includes a 2K FIFO, supports I2C/I3C/SPI, and provides
intelligent motion features like pedometer, tilt detection,
and tap detection.
Signed-off-by: Jean-Baptiste Maneyrol <jmaneyrol@invensense.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
