- Remove the "log-like" parts, following the same logic as the previous
commit
- Unify format
- Add missing major contributors, including myself
- Sort entries in order of first contribution (Creative comes last for
optical reasons; they don't appear to have directly contributed
anyway)
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230715160839.326978-2-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Empty BUGS and TODO sections don't really help anyone, so remove them.
Version information is chronically outdated, and not really useful in a
git world anyway, so remove it as well.
Also remove duplicated (and outdated, of course) status section from
p16v.h (the one in p16v.c is in better shape).
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230715160839.326978-1-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The value isn't used yet; the subsequent commits will do that.
This ignores the existence of rates above 48 kHz, which is fine, as the
hardware will just switch to the fallback clock source when fed with a
rate which is incompatible with the base clock multiplier, which
currently is always x1.
The sample rate display in /proc spdif-in is adjusted to reflect our
understanding of the input rates.
This is tested only with an 0404b card without sync card, so there is a
lot of room for improvement.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230612191325.1315854-4-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The actually available clock sources depend on the available audio input
ports and dedicated clock input ports.
This includes refactoring the code to be data-driven to remain
manageable.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230612191325.1315854-3-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Include the routing information, which can be actually read back.
Somewhat as a drive-by, make the register dump format less obscure - the
previous one made no sense at all.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230526101659.437969-6-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
We use independent voices for the channels, so we need to make an effort
to ensure that they are actually in sync.
The hardware doesn't provide atomicity, so we may need to retry a few
times, due to NMIs, PCI contention, and the wrong phase of the moon.
Solution inspired by kX-project.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230523200709.236023-3-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
While this nicely denoises the code, the real intent is being able to
write many registers pseudo-atomically, which will come in handy later.
Idea stolen from kX-project.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230518093134.3697955-1-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
We initialize them at card init and don't touch them later, so there is
no need to reset them again at voice start.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230516093612.3536451-4-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
We (rightfully) don't enable the envelope engine for PCM voices, so any
related setup is entirely pointless - the EMU8K documentation makes that
very clear, and the fact that the various open drivers all use different
values to no observable detriment pretty much confirms it.
The remaining initializations are regrouped for clarity.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230516093612.3536451-3-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Rather than applying masks to the provided values, make assertions
about them being valid - otherwise we'd just try to paper over bugs.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230514170323.3408798-2-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Using the *_MASK defines for "maximal value" is debatable. I got the
idea from FreeBSD, and it sorta makes sense to me.
Some hunks look a bit incomplete, because code that is going to be
subsequently removed is not touched here.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230428080732.1697695-1-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Move comments to better locations, de-duplicate, fix/remove incorrect/
outdated ones, add new ones, and unify spacing somewhat.
While at it, also add testing credits for Jonathan Dowland (SB Live!
Platinum) and myself (E-MU 0404b).
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230422161021.1143903-2-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Unlike the Alice2 chips used on 1st generation E-MU cards, the
Tina/Tina2 chips used on the 2nd gen cards have only six GPIN pins,
which means that we need to use a smaller mask. Failure to do so would
falsify the read data if the FPGA tried to raise an IRQ right at that
moment. This wasn't a problem so far, as we didn't actually enable FPGA
IRQs, but that's going to change soon.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230422132430.1057490-1-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
As the register definition clearly states, this is a 16-bit register,
yet we did all accesses as 32-bit. The writes in particular would have
the potential to clear the TIMER register (depending on how the bus/card
actually handles the too long writes).
This commit also introduces a separate define A_GPIO which aliases
A_IOCFG, which better reflects the distinct usage on E-MU cards.
This is done in the same commit to keep the churn down, as we're
touching all involved lines anyway.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230421141006.1005539-2-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Assert the validity of the registers and values, as them being out of
range would indicate an error in the driver. Consequently, don't bother
returning error codes; they were ignored everywhere anyway.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230421141006.1005539-1-oswald.buddenhagen@gmx.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Apply const prefix to the remaining possible places: the static tables
for init verbs and registers, the string arrays, the conversion
tables, etc.
Just for minor optimization and no functional changes.
Link: https://lore.kernel.org/r/20200105144823.29547-15-tiwai@suse.de
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Based on 1 normalized pattern(s):
this program is free software you can redistribute it and or modify
it under the terms of the gnu general public license as published by
the free software foundation either version 2 of the license or at
your option any later version this program is distributed in the
hope that it will be useful but without any warranty without even
the implied warranty of merchantability or fitness for a particular
purpose see the gnu general public license for more details you
should have received a copy of the gnu general public license along
with this program if not write to the free software foundation inc
59 temple place suite 330 boston ma 02111 1307 usa
extracted by the scancode license scanner the SPDX license identifier
GPL-2.0-or-later
has been chosen to replace the boilerplate/reference in 1334 file(s).
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Reviewed-by: Allison Randal <allison@lohutok.net>
Reviewed-by: Richard Fontana <rfontana@redhat.com>
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190527070033.113240726@linutronix.de
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
The previous dev_err() conversion resulted in a code that may give
NULL dereference in snd_emu10k1_ptr_write(). Since it's a sanity
check, better to be replaced with a debug macro like other places in
this driver.
Fixes: 6f002b0216 ('ALSA: emu10k1: Use standard printk helpers')
Reported-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
These aren't modules, but they do make use of these macros, so
they will need export.h to get that definition. Previously,
they got it via the implicit module.h inclusion.
Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
The variables are unsigned so the test `>= 0' is always true,
the `< 0' test always fails. In these cases the other part of
the test catches wrapped values.
In dac_audio_write() there does not occur a test for wrapped
values, but the test appears redundant.
Signed-off-by: Roel Kluin <roel.kluin@gmail.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
This header file exists only for some hacks to adapt alsa-driver
tree. It's useless for building in the kernel. Let's move a few
lines in it to sound/core.h and remove it.
With this patch, sound/driver.h isn't removed but has just a single
compile warning to include it. This should be really killed in
future.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@perex.cz>
Implement functionallity in order to fixe ALSA bug#2058.
Signed-off-by: James Courtier-Dutton <James@superbug.co.uk>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Modules: EMU10K1/EMU10K2 driver
Description:
Part way to fix ALSA bug#927
Add support for the SPI interface on the CA0108 chip.
This is used to control the registers on the DAC.
Headphone output tested.
Other outputs and Capture not tested yet.
Note: The red LED does not come on, but sound is still OK.
Signed-off-by: James Courtier-Dutton <James@superbug.co.uk>
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
