asm/unaligned.h is always an include of asm-generic/unaligned.h;
might as well move that thing to linux/unaligned.h and include
that - there's nothing arch-specific in that header.
auto-generated by the following:
for i in `git grep -l -w asm/unaligned.h`; do
sed -i -e "s/asm\/unaligned.h/linux\/unaligned.h/" $i
done
for i in `git grep -l -w asm-generic/unaligned.h`; do
sed -i -e "s/asm-generic\/unaligned.h/linux\/unaligned.h/" $i
done
git mv include/asm-generic/unaligned.h include/linux/unaligned.h
git mv tools/include/asm-generic/unaligned.h tools/include/linux/unaligned.h
sed -i -e "/unaligned.h/d" include/asm-generic/Kbuild
sed -i -e "s/__ASM_GENERIC/__LINUX/" include/linux/unaligned.h tools/include/linux/unaligned.h
Rationale:
Reduces attack surface on kernel devs opening the links for MITM
as HTTPS traffic is much harder to manipulate.
Deterministic algorithm:
For each file:
If not .svg:
For each line:
If doesn't contain `\bxmlns\b`:
For each link, `\bhttp://[^# \t\r\n]*(?:\w|/)`:
If neither `\bgnu\.org/license`, nor `\bmozilla\.org/MPL\b`:
If both the HTTP and HTTPS versions
return 200 OK and serve the same content:
Replace HTTP with HTTPS.
Signed-off-by: Alexander A. Klimov <grandmaster@al2klimov.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Based on 1 normalized pattern(s):
this program is free software you can redistribute it and or modify
it under the terms of the gnu general public license as published by
the free software foundation either version 2 of the license or at
your option any later version
extracted by the scancode license scanner the SPDX license identifier
GPL-2.0-or-later
has been chosen to replace the boilerplate/reference in 3029 file(s).
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Reviewed-by: Allison Randal <allison@lohutok.net>
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190527070032.746973796@linutronix.de
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Use subsys_initcall for registration of all templates and generic
algorithm implementations, rather than module_init. Then change
cryptomgr to use arch_initcall, to place it before the subsys_initcalls.
This is needed so that when both a generic and optimized implementation
of an algorithm are built into the kernel (not loadable modules), the
generic implementation is registered before the optimized one.
Otherwise, the self-tests for the optimized implementation are unable to
allocate the generic implementation for the new comparison fuzz tests.
Note that on arm, a side effect of this change is that self-tests for
generic implementations may run before the unaligned access handler has
been installed. So, unaligned accesses will crash the kernel. This is
arguably a good thing as it makes it easier to detect that type of bug.
Signed-off-by: Eric Biggers <ebiggers@google.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Many shash algorithms set .cra_flags = CRYPTO_ALG_TYPE_SHASH. But this
is redundant with the C structure type ('struct shash_alg'), and
crypto_register_shash() already sets the type flag automatically,
clearing any type flag that was already there. Apparently the useless
assignment has just been copy+pasted around.
So, remove the useless assignment from all the shash algorithms.
This patch shouldn't change any actual behavior.
Signed-off-by: Eric Biggers <ebiggers@google.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
keccakf() is the only function in kernel that uses __optimize() macro.
__optimize() breaks frame pointer unwinder as optimized code uses RBP,
and amusingly this always lead to degraded performance as gcc does not
inline across different optimizations levels, so keccakf() wasn't inlined
into its callers and keccakf_round() wasn't inlined into keccakf().
Drop __optimize() to resolve both problems.
Signed-off-by: Dmitry Vyukov <dvyukov@google.com>
Fixes: 83dee2ce1a ("crypto: sha3-generic - rewrite KECCAK transform to help the compiler optimize")
Reported-by: syzbot+37035ccfa9a0a017ffcf@syzkaller.appspotmail.com
Reported-by: syzbot+e073e4740cfbb3ae200b@syzkaller.appspotmail.com
Cc: linux-crypto@vger.kernel.org
Cc: "David S. Miller" <davem@davemloft.net>
Cc: Herbert Xu <herbert@gondor.apana.org.au>
Cc: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Acked-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
As reported by kbuild test robot, the optimized SHA3 C implementation
compiles to mn10300 code that uses a disproportionate amount of stack
space, i.e.,
crypto/sha3_generic.c: In function 'keccakf':
crypto/sha3_generic.c:147:1: warning: the frame size of 1232 bytes is larger than 1024 bytes [-Wframe-larger-than=]
As kindly diagnosed by Arnd, this does not only occur when building for
the mn10300 architecture (which is what the report was about) but also
for h8300, and builds for other 32-bit architectures show an increase in
stack space utilization as well.
Given that SHA3 operates on 64-bit quantities, and keeps a state matrix
of 25 64-bit words, it is not surprising that 32-bit architectures with
few general purpose registers are impacted the most by this, and it is
therefore reasonable to implement a workaround that distinguishes between
32-bit and 64-bit architectures.
Arnd figured out that taking the round calculation out of the loop, and
inlining it explicitly but only on 64-bit architectures preserves most
of the performance gain achieved by the rewrite, and also gets rid of
the excessive use of stack space.
Reported-by: kbuild test robot <fengguang.wu@intel.com>
Suggested-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
To allow accelerated implementations to fall back to the generic
routines, e.g., in contexts where a SIMD based implementation is
not allowed to run, expose the generic SHA3 init/update/final
routines to other modules.
Signed-off-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
In preparation of exposing the generic SHA3 implementation to other
versions as a fallback, simplify the code, and remove an inconsistency
in the output handling (endian swabbing rsizw words of state before
writing the output does not make sense)
Signed-off-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
The way the KECCAK transform is currently coded involves many references
into the state array using indexes that are calculated at runtime using
simple but non-trivial arithmetic. This forces the compiler to treat the
state matrix as an array in memory rather than keep it in registers,
which results in poor performance.
So instead, let's rephrase the algorithm using fixed array indexes only.
This helps the compiler keep the state matrix in registers, resulting
in the following speedup (SHA3-256 performance in cycles per byte):
before after speedup
Intel Core i7 @ 2.0 GHz (2.9 turbo) 100.6 35.7 2.8x
Cortex-A57 @ 2.0 GHz (64-bit mode) 101.6 12.7 8.0x
Cortex-A53 @ 1.0 GHz 224.4 15.8 14.2x
Cortex-A57 @ 2.0 GHz (32-bit mode) 201.8 63.0 3.2x
Signed-off-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Ensure that the input is byte swabbed before injecting it into the
SHA3 transform. Use the get_unaligned() accessor for this so that
we don't perform unaligned access inadvertently on architectures
that do not support that.
Cc: <stable@vger.kernel.org>
Fixes: 53964b9ee6 ("crypto: sha3 - Add SHA-3 hash algorithm")
Signed-off-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
On 32-bit (e.g. with m68k-linux-gnu-gcc-4.1):
crypto/sha3_generic.c:27: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:28: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:29: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:29: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:31: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:31: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:32: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:32: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:32: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:33: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:33: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:34: warning: integer constant is too large for ‘long’ type
crypto/sha3_generic.c:34: warning: integer constant is too large for ‘long’ type
Fixes: 53964b9ee6 ("crypto: sha3 - Add SHA-3 hash algorithm")
Signed-off-by: Geert Uytterhoeven <geert@linux-m68k.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
This patch adds the implementation of SHA3 algorithm
in software and it's based on original implementation
pushed in patch https://lwn.net/Articles/518415/ with
additional changes to match the padding rules specified
in SHA-3 specification.
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
Signed-off-by: Raveendra Padasalagi <raveendra.padasalagi@broadcom.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
