mtd: rawnand: denali: remove ->erase hook

Commit f9ebd1bb41 ("mtd: rawnand: Deprecate ->erase()") discouraged
the use of this hook, so I am happy to follow the suggestion.

Although the Denali IP provides a special MAP10 command for erasing,
using it would not buy us much. The Denali IP actually works with the
generic erasing by single_erase() + ->cmdfunc hook (nand_command_lp)
+ ->cmd_ctrl hook (denali_cmd_ctrl).

This method is also deprecated, but denali_erase() can go away
irrespective of ->exec_op conversion.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Reviewed-by: Boris Brezillon <bbrezillon@kernel.org>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
This commit is contained in:
Masahiro Yamada 2019-01-21 13:52:06 +09:00 committed by Miquel Raynal
parent 3175e12183
commit d4ea6ed022

View File

@ -37,9 +37,6 @@
#define DENALI_MAP11_ADDR ((DENALI_MAP11) | 1) /* address cycle */
#define DENALI_MAP11_DATA ((DENALI_MAP11) | 2) /* data cycle */
/* MAP10 commands */
#define DENALI_ERASE 0x01
#define DENALI_BANK(denali) ((denali)->active_bank << 24)
#define DENALI_INVALID_BANK -1
@ -903,23 +900,6 @@ static int denali_waitfunc(struct nand_chip *chip)
return irq_status & INTR__INT_ACT ? 0 : NAND_STATUS_FAIL;
}
static int denali_erase(struct nand_chip *chip, int page)
{
struct denali_nand_info *denali = mtd_to_denali(nand_to_mtd(chip));
uint32_t irq_status;
denali_reset_irq(denali);
denali->host_write(denali, DENALI_MAP10 | DENALI_BANK(denali) | page,
DENALI_ERASE);
/* wait for erase to complete or failure to occur */
irq_status = denali_wait_for_irq(denali,
INTR__ERASE_COMP | INTR__ERASE_FAIL);
return irq_status & INTR__ERASE_COMP ? 0 : -EIO;
}
static int denali_setup_data_interface(struct nand_chip *chip, int chipnr,
const struct nand_data_interface *conf)
{
@ -1244,7 +1224,6 @@ static int denali_attach_chip(struct nand_chip *chip)
chip->ecc.write_page_raw = denali_write_page_raw;
chip->ecc.read_oob = denali_read_oob;
chip->ecc.write_oob = denali_write_oob;
chip->legacy.erase = denali_erase;
ret = denali_multidev_fixup(denali);
if (ret)