Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/bart/ide-2.6

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/bart/ide-2.6:
  MAINTAINERS: update IDE entry
  palm_bk3710: palm_bk3710_udmatimings[] CodingStyle fixup
  palm_bk3710: those registers/bitfields don't exist
  mediabay: fix build for CONFIG_BLOCK=n
  ide: Stop disks on reboot for laptop which cuts power
  ide-cd: fix kernel crash on hppa regression
  palm_bk3710: UDMA performance fix
This commit is contained in:
Linus Torvalds 2009-04-24 08:16:05 -07:00
commit d1f53fb90e
5 changed files with 48 additions and 67 deletions

View File

@ -2758,7 +2758,7 @@ IDE SUBSYSTEM
P: Bartlomiej Zolnierkiewicz
M: bzolnier@gmail.com
L: linux-ide@vger.kernel.org
T: quilt kernel.org/pub/linux/kernel/people/bart/pata-2.6/
T: git git://git.kernel.org/pub/scm/linux/kernel/git/bart/ide-2.6.git
S: Maintained
F: Documentation/ide/
F: drivers/ide/

View File

@ -609,7 +609,7 @@ static ide_startstop_t cdrom_newpc_intr(ide_drive_t *drive)
struct request *rq = hwif->rq;
ide_expiry_t *expiry = NULL;
int dma_error = 0, dma, thislen, uptodate = 0;
int write = (rq_data_dir(rq) == WRITE) ? 1 : 0, rc, nsectors;
int write = (rq_data_dir(rq) == WRITE) ? 1 : 0, rc = 0, nsectors;
int sense = blk_sense_request(rq);
unsigned int timeout;
u16 len;

View File

@ -7,6 +7,7 @@
#include <linux/mutex.h>
#include <linux/ide.h>
#include <linux/hdreg.h>
#include <linux/dmi.h>
#if !defined(CONFIG_DEBUG_BLOCK_EXT_DEVT)
#define IDE_DISK_MINORS (1 << PARTN_BITS)
@ -99,6 +100,19 @@ static void ide_gd_resume(ide_drive_t *drive)
(void)drive->disk_ops->get_capacity(drive);
}
static const struct dmi_system_id ide_coldreboot_table[] = {
{
/* Acer TravelMate 66x cuts power during reboot */
.ident = "Acer TravelMate 660",
.matches = {
DMI_MATCH(DMI_SYS_VENDOR, "Acer"),
DMI_MATCH(DMI_PRODUCT_NAME, "TravelMate 660"),
},
},
{ } /* terminate list */
};
static void ide_gd_shutdown(ide_drive_t *drive)
{
#ifdef CONFIG_ALPHA
@ -115,7 +129,8 @@ static void ide_gd_shutdown(ide_drive_t *drive)
the disk to expire its write cache. */
if (system_state != SYSTEM_POWER_OFF) {
#else
if (system_state == SYSTEM_RESTART) {
if (system_state == SYSTEM_RESTART &&
!dmi_check_system(ide_coldreboot_table)) {
#endif
drive->disk_ops->flush(drive);
return;

View File

@ -39,27 +39,12 @@
/* Primary Control Offset */
#define IDE_PALM_ATA_PRI_CTL_OFFSET 0x3F6
/*
* PalmChip 3710 IDE Controller UDMA timing structure Definition
*/
struct palm_bk3710_udmatiming {
unsigned int rptime; /* Ready to pause time */
unsigned int cycletime; /* Cycle Time */
};
#define BK3710_BMICP 0x00
#define BK3710_BMISP 0x02
#define BK3710_BMIDTP 0x04
#define BK3710_BMICS 0x08
#define BK3710_BMISS 0x0A
#define BK3710_BMIDTS 0x0C
#define BK3710_IDETIMP 0x40
#define BK3710_IDETIMS 0x42
#define BK3710_SIDETIM 0x44
#define BK3710_SLEWCTL 0x45
#define BK3710_IDESTATUS 0x47
#define BK3710_UDMACTL 0x48
#define BK3710_UDMATIM 0x4A
#define BK3710_MISCCTL 0x50
#define BK3710_REGSTB 0x54
#define BK3710_REGRCVR 0x58
@ -71,17 +56,22 @@ struct palm_bk3710_udmatiming {
#define BK3710_UDMATRP 0x70
#define BK3710_UDMAENV 0x74
#define BK3710_IORDYTMP 0x78
#define BK3710_IORDYTMS 0x7C
static unsigned ideclk_period; /* in nanoseconds */
struct palm_bk3710_udmatiming {
unsigned int rptime; /* tRP -- Ready to pause time (nsec) */
unsigned int cycletime; /* tCYCTYP2/2 -- avg Cycle Time (nsec) */
/* tENV is always a minimum of 20 nsec */
};
static const struct palm_bk3710_udmatiming palm_bk3710_udmatimings[6] = {
{160, 240}, /* UDMA Mode 0 */
{125, 160}, /* UDMA Mode 1 */
{100, 120}, /* UDMA Mode 2 */
{100, 90}, /* UDMA Mode 3 */
{100, 60}, /* UDMA Mode 4 */
{85, 40}, /* UDMA Mode 5 */
{ 160, 240 / 2 }, /* UDMA Mode 0 */
{ 125, 160 / 2 }, /* UDMA Mode 1 */
{ 100, 120 / 2 }, /* UDMA Mode 2 */
{ 100, 90 / 2 }, /* UDMA Mode 3 */
{ 100, 60 / 2 }, /* UDMA Mode 4 */
{ 85, 40 / 2 }, /* UDMA Mode 5 */
};
static void palm_bk3710_setudmamode(void __iomem *base, unsigned int dev,
@ -98,11 +88,6 @@ static void palm_bk3710_setudmamode(void __iomem *base, unsigned int dev,
trp = DIV_ROUND_UP(palm_bk3710_udmatimings[mode].rptime,
ideclk_period) - 1;
/* udmatim Register */
val16 = readw(base + BK3710_UDMATIM) & (dev ? 0xFF0F : 0xFFF0);
val16 |= (mode << (dev ? 4 : 0));
writew(val16, base + BK3710_UDMATIM);
/* udmastb Ultra DMA Access Strobe Width */
val32 = readl(base + BK3710_UDMASTB) & (0xFF << (dev ? 0 : 8));
val32 |= (t0 << (dev ? 8 : 0));
@ -163,10 +148,11 @@ static void palm_bk3710_setpiomode(void __iomem *base, ide_drive_t *mate,
u32 val32;
struct ide_timing *t;
t = ide_timing_find_mode(XFER_PIO_0 + mode);
/* PIO Data Setup */
t0 = DIV_ROUND_UP(cycletime, ideclk_period);
t2 = DIV_ROUND_UP(ide_timing_find_mode(XFER_PIO_0 + mode)->active,
ideclk_period);
t2 = DIV_ROUND_UP(t->active, ideclk_period);
t2i = t0 - t2 - 1;
t2 -= 1;
@ -187,7 +173,6 @@ static void palm_bk3710_setpiomode(void __iomem *base, ide_drive_t *mate,
}
/* TASKFILE Setup */
t = ide_timing_find_mode(XFER_PIO_0 + mode);
t0 = DIV_ROUND_UP(t->cyc8b, ideclk_period);
t2 = DIV_ROUND_UP(t->act8b, ideclk_period);
@ -236,42 +221,23 @@ static void palm_bk3710_set_pio_mode(ide_drive_t *drive, u8 pio)
static void __devinit palm_bk3710_chipinit(void __iomem *base)
{
/*
* enable the reset_en of ATA controller so that when ata signals
* are brought out, by writing into device config. at that
* time por_n signal should not be 'Z' and have a stable value.
* REVISIT: the ATA reset signal needs to be managed through a
* GPIO, which means it should come from platform_data. Until
* we get and use such information, we have to trust that things
* have been reset before we get here.
*/
writel(0x0300, base + BK3710_MISCCTL);
/* wait for some time and deassert the reset of ATA Device. */
mdelay(100);
/* Deassert the Reset */
writel(0x0200, base + BK3710_MISCCTL);
/*
* Program the IDETIMP Register Value based on the following assumptions
*
* (ATA_IDETIMP_IDEEN , ENABLE ) |
* (ATA_IDETIMP_SLVTIMEN , DISABLE) |
* (ATA_IDETIMP_RDYSMPL , 70NS) |
* (ATA_IDETIMP_RDYRCVRY , 50NS) |
* (ATA_IDETIMP_DMAFTIM1 , PIOCOMP) |
* (ATA_IDETIMP_PREPOST1 , DISABLE) |
* (ATA_IDETIMP_RDYSEN1 , DISABLE) |
* (ATA_IDETIMP_PIOFTIM1 , DISABLE) |
* (ATA_IDETIMP_DMAFTIM0 , PIOCOMP) |
* (ATA_IDETIMP_PREPOST0 , DISABLE) |
* (ATA_IDETIMP_RDYSEN0 , DISABLE) |
* (ATA_IDETIMP_PIOFTIM0 , DISABLE)
*
* DM6446 silicon rev 2.1 and earlier have no observed net benefit
* from enabling prefetch/postwrite.
*/
writew(0xB388, base + BK3710_IDETIMP);
/*
* Configure SIDETIM Register
* (ATA_SIDETIM_RDYSMPS1 ,120NS ) |
* (ATA_SIDETIM_RDYRCYS1 ,120NS )
*/
writeb(0, base + BK3710_SIDETIM);
writew(BIT(15), base + BK3710_IDETIMP);
/*
* UDMACTL Ultra-ATA DMA Control
@ -283,11 +249,11 @@ static void __devinit palm_bk3710_chipinit(void __iomem *base)
/*
* MISCCTL Miscellaneous Conrol Register
* (ATA_MISCCTL_RSTMODEP , 1) |
* (ATA_MISCCTL_RESETP , 0) |
* (ATA_MISCCTL_HWNHLD1P , 1 cycle)
* (ATA_MISCCTL_HWNHLD0P , 1 cycle)
* (ATA_MISCCTL_TIMORIDE , 1)
*/
writel(0x201, base + BK3710_MISCCTL);
writel(0x001, base + BK3710_MISCCTL);
/*
* IORDYTMP IORDY Timer for Primary Register
@ -357,10 +323,9 @@ static int __init palm_bk3710_probe(struct platform_device *pdev)
clk_enable(clk);
rate = clk_get_rate(clk);
ideclk_period = 1000000000UL / rate;
/* Register the IDE interface with Linux ATA Interface */
memset(&hw, 0, sizeof(hw));
/* NOTE: round *down* to meet minimum timings; we count in clocks */
ideclk_period = 1000000000UL / rate;
mem = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (mem == NULL) {
@ -390,6 +355,7 @@ static int __init palm_bk3710_probe(struct platform_device *pdev)
/* Configure the Palm Chip controller */
palm_bk3710_chipinit(base);
memset(&hw, 0, sizeof(hw));
for (i = 0; i < IDE_NR_PORTS - 2; i++)
hw.io_ports_array[i] = (unsigned long)
(base + IDE_PALM_ATA_PRI_REG_OFFSET + i);
@ -402,6 +368,7 @@ static int __init palm_bk3710_probe(struct platform_device *pdev)
palm_bk3710_port_info.udma_mask = rate < 100000000 ? ATA_UDMA4 :
ATA_UDMA5;
/* Register the IDE interface with Linux */
rc = ide_host_add(&palm_bk3710_port_info, hws, NULL);
if (rc)
goto out;

View File

@ -18,7 +18,6 @@
#include <linux/timer.h>
#include <linux/stddef.h>
#include <linux/init.h>
#include <linux/ide.h>
#include <linux/kthread.h>
#include <linux/mutex.h>
#include <asm/prom.h>