[PATCH] ide: clean up pdc202xx_old so its more readable (done so I could work on libata ports)

Also sets the new fifo flag so that we don't hang on some errors with this
chipset.

Signed-off-by: Alan Cox <alan@redhat.com>
Cc: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl>
Cc: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
This commit is contained in:
Alan Cox 2006-06-28 04:27:03 -07:00 committed by Linus Torvalds
parent f201f5046d
commit 57e834e2fb

View File

@ -101,31 +101,6 @@ static const char *pdc_quirk_drives[] = {
#define MC1 0x02 /* DMA"C" timing */
#define MC0 0x01 /* DMA"C" timing */
#if 0
unsigned long bibma = pci_resource_start(dev, 4);
u8 hi = 0, lo = 0;
u8 sc1c = inb_p((u16)bibma + 0x1c);
u8 sc1e = inb_p((u16)bibma + 0x1e);
u8 sc1f = inb_p((u16)bibma + 0x1f);
p += sprintf(p, "Host Mode : %s\n",
(sc1f & 0x08) ? "Tri-Stated" : "Normal");
p += sprintf(p, "Bus Clocking : %s\n",
((sc1f & 0xC0) == 0xC0) ? "100 External" :
((sc1f & 0x80) == 0x80) ? "66 External" :
((sc1f & 0x40) == 0x40) ? "33 External" : "33 PCI Internal");
p += sprintf(p, "IO pad select : %s mA\n",
((sc1c & 0x03) == 0x03) ? "10" :
((sc1c & 0x02) == 0x02) ? "8" :
((sc1c & 0x01) == 0x01) ? "6" :
((sc1c & 0x00) == 0x00) ? "4" : "??");
hi = sc1e >> 4;
lo = sc1e & 0xf;
p += sprintf(p, "Status Polling Period : %d\n", hi);
p += sprintf(p, "Interrupt Check Status Polling Delay : %d\n", lo);
#endif
static u8 pdc202xx_ratemask (ide_drive_t *drive)
{
u8 mode;
@ -505,42 +480,13 @@ static void pdc202xx_reset (ide_drive_t *drive)
pdc202xx_reset_host(hwif);
pdc202xx_reset_host(mate);
#if 0
/*
* FIXME: Have to kick all the drives again :-/
* What a pain in the ACE!
*/
if (hwif->present) {
u16 hunit = 0;
for (hunit = 0; hunit < MAX_DRIVES; ++hunit) {
ide_drive_t *hdrive = &hwif->drives[hunit];
if (hdrive->present) {
if (hwif->ide_dma_check)
hwif->ide_dma_check(hdrive);
else
hwif->tuneproc(hdrive, 5);
}
}
}
if (mate->present) {
u16 munit = 0;
for (munit = 0; munit < MAX_DRIVES; ++munit) {
ide_drive_t *mdrive = &mate->drives[munit];
if (mdrive->present) {
if (mate->ide_dma_check)
mate->ide_dma_check(mdrive);
else
mate->tuneproc(mdrive, 5);
}
}
}
#else
hwif->tuneproc(drive, 5);
#endif
}
static unsigned int __devinit init_chipset_pdc202xx(struct pci_dev *dev, const char *name)
static unsigned int __devinit init_chipset_pdc202xx(struct pci_dev *dev,
const char *name)
{
/* This doesn't appear needed */
if (dev->resource[PCI_ROM_RESOURCE].start) {
pci_write_config_dword(dev, PCI_ROM_ADDRESS,
dev->resource[PCI_ROM_RESOURCE].start | PCI_ROM_ADDRESS_ENABLE);
@ -548,30 +494,6 @@ static unsigned int __devinit init_chipset_pdc202xx(struct pci_dev *dev, const c
name, dev->resource[PCI_ROM_RESOURCE].start);
}
/*
* software reset - this is required because the bios
* will set UDMA timing on if the hdd supports it. The
* user may want to turn udma off. A bug in the pdc20262
* is that it cannot handle a downgrade in timing from
* UDMA to DMA. Disk accesses after issuing a set
* feature command will result in errors. A software
* reset leaves the timing registers intact,
* but resets the drives.
*/
#if 0
if ((dev->device == PCI_DEVICE_ID_PROMISE_20267) ||
(dev->device == PCI_DEVICE_ID_PROMISE_20265) ||
(dev->device == PCI_DEVICE_ID_PROMISE_20263) ||
(dev->device == PCI_DEVICE_ID_PROMISE_20262)) {
unsigned long high_16 = pci_resource_start(dev, 4);
byte udma_speed_flag = inb(high_16 + 0x001f);
outb(udma_speed_flag | 0x10, high_16 + 0x001f);
mdelay(100);
outb(udma_speed_flag & ~0x10, high_16 + 0x001f);
mdelay(2000); /* 2 seconds ?! */
}
#endif
return dev->irq;
}
@ -599,6 +521,8 @@ static void __devinit init_hwif_pdc202xx(ide_hwif_t *hwif)
hwif->mwdma_mask = 0x07;
hwif->swdma_mask = 0x07;
hwif->err_stops_fifo = 1;
hwif->ide_dma_check = &pdc202xx_config_drive_xfer_rate;
hwif->ide_dma_lostirq = &pdc202xx_ide_dma_lostirq;
hwif->ide_dma_timeout = &pdc202xx_ide_dma_timeout;
@ -687,19 +611,6 @@ static int __devinit init_setup_pdc202ata4(struct pci_dev *dev,
"mirror fixed.\n", d->name);
}
}
#if 0
if (dev->device == PCI_DEVICE_ID_PROMISE_20262)
if (e->reg && (pci_read_config_byte(dev, e->reg, &tmp) ||
(tmp & e->mask) != e->val))
if (d->enablebits[0].reg != d->enablebits[1].reg) {
d->enablebits[0].reg = d->enablebits[1].reg;
d->enablebits[0].mask = d->enablebits[1].mask;
d->enablebits[0].val = d->enablebits[1].val;
}
#endif
return ide_setup_pci_device(dev, d);
}
@ -714,22 +625,6 @@ static int __devinit init_setup_pdc20265(struct pci_dev *dev,
"attached to I2O RAID controller.\n");
return -ENODEV;
}
#if 0
{
u8 pri = 0, sec = 0;
if (e->reg && (pci_read_config_byte(dev, e->reg, &tmp) ||
(tmp & e->mask) != e->val))
if (d->enablebits[0].reg != d->enablebits[1].reg) {
d->enablebits[0].reg = d->enablebits[1].reg;
d->enablebits[0].mask = d->enablebits[1].mask;
d->enablebits[0].val = d->enablebits[1].val;
}
}
#endif
return ide_setup_pci_device(dev, d);
}