mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-11-19 18:24:14 +08:00
mtd: nand: atmel: rely on generic DT parsing done in nand_scan_ident()
The core now takes care of parsing generic DT properties in nand_scan_ident() when nand_set_flash_node() has been called. Rely on this initialization instead of calling of_get_nand_xxx() manually. Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com> Tested-by: Boris Brezillon <boris.brezillon@free-electrons.com> Reviewed-by: Nicolas Ferre <nicolas.ferre@atmel.com>
This commit is contained in:
Boris Brezillon
parent
ff05fdb187
commit
4f3cab9b44
@ -36,7 +36,6 @@
|
||||
#include <linux/of.h>
|
||||
#include <linux/of_device.h>
|
||||
#include <linux/of_gpio.h>
|
||||
#include <linux/of_mtd.h>
|
||||
#include <linux/mtd/mtd.h>
|
||||
#include <linux/mtd/nand.h>
|
||||
#include <linux/mtd/partitions.h>
|
||||
@ -434,14 +433,13 @@ err_buf:
|
||||
static void atmel_read_buf(struct mtd_info *mtd, u8 *buf, int len)
|
||||
{
|
||||
struct nand_chip *chip = mtd_to_nand(mtd);
|
||||
struct atmel_nand_host *host = nand_get_controller_data(chip);
|
||||
|
||||
if (use_dma && len > mtd->oobsize)
|
||||
/* only use DMA for bigger than oob size: better performances */
|
||||
if (atmel_nand_dma_op(mtd, buf, len, 1) == 0)
|
||||
return;
|
||||
|
||||
if (host->board.bus_width_16)
|
||||
if (chip->options & NAND_BUSWIDTH_16)
|
||||
atmel_read_buf16(mtd, buf, len);
|
||||
else
|
||||
atmel_read_buf8(mtd, buf, len);
|
||||
@ -450,14 +448,13 @@ static void atmel_read_buf(struct mtd_info *mtd, u8 *buf, int len)
|
||||
static void atmel_write_buf(struct mtd_info *mtd, const u8 *buf, int len)
|
||||
{
|
||||
struct nand_chip *chip = mtd_to_nand(mtd);
|
||||
struct atmel_nand_host *host = nand_get_controller_data(chip);
|
||||
|
||||
if (use_dma && len > mtd->oobsize)
|
||||
/* only use DMA for bigger than oob size: better performances */
|
||||
if (atmel_nand_dma_op(mtd, (void *)buf, len, 0) == 0)
|
||||
return;
|
||||
|
||||
if (host->board.bus_width_16)
|
||||
if (chip->options & NAND_BUSWIDTH_16)
|
||||
atmel_write_buf16(mtd, buf, len);
|
||||
else
|
||||
atmel_write_buf8(mtd, buf, len);
|
||||
@ -1507,58 +1504,17 @@ static void atmel_nand_hwctl(struct mtd_info *mtd, int mode)
|
||||
ecc_writel(host->ecc, CR, ATMEL_ECC_RST);
|
||||
}
|
||||
|
||||
static int atmel_of_init_port(struct atmel_nand_host *host,
|
||||
struct device_node *np)
|
||||
static int atmel_of_init_ecc(struct atmel_nand_host *host,
|
||||
struct device_node *np)
|
||||
{
|
||||
u32 val;
|
||||
u32 offset[2];
|
||||
int ecc_mode;
|
||||
struct atmel_nand_data *board = &host->board;
|
||||
enum of_gpio_flags flags = 0;
|
||||
|
||||
host->caps = (struct atmel_nand_caps *)
|
||||
of_device_get_match_data(host->dev);
|
||||
|
||||
if (of_property_read_u32(np, "atmel,nand-addr-offset", &val) == 0) {
|
||||
if (val >= 32) {
|
||||
dev_err(host->dev, "invalid addr-offset %u\n", val);
|
||||
return -EINVAL;
|
||||
}
|
||||
board->ale = val;
|
||||
}
|
||||
|
||||
if (of_property_read_u32(np, "atmel,nand-cmd-offset", &val) == 0) {
|
||||
if (val >= 32) {
|
||||
dev_err(host->dev, "invalid cmd-offset %u\n", val);
|
||||
return -EINVAL;
|
||||
}
|
||||
board->cle = val;
|
||||
}
|
||||
|
||||
ecc_mode = of_get_nand_ecc_mode(np);
|
||||
|
||||
board->ecc_mode = ecc_mode < 0 ? NAND_ECC_SOFT : ecc_mode;
|
||||
|
||||
board->on_flash_bbt = of_get_nand_on_flash_bbt(np);
|
||||
|
||||
board->has_dma = of_property_read_bool(np, "atmel,nand-has-dma");
|
||||
|
||||
if (of_get_nand_bus_width(np) == 16)
|
||||
board->bus_width_16 = 1;
|
||||
|
||||
board->rdy_pin = of_get_gpio_flags(np, 0, &flags);
|
||||
board->rdy_pin_active_low = (flags == OF_GPIO_ACTIVE_LOW);
|
||||
|
||||
board->enable_pin = of_get_gpio(np, 1);
|
||||
board->det_pin = of_get_gpio(np, 2);
|
||||
u32 val;
|
||||
|
||||
host->has_pmecc = of_property_read_bool(np, "atmel,has-pmecc");
|
||||
|
||||
/* load the nfc driver if there is */
|
||||
of_platform_populate(np, NULL, NULL, host->dev);
|
||||
|
||||
if (!(board->ecc_mode == NAND_ECC_HW) || !host->has_pmecc)
|
||||
return 0; /* Not using PMECC */
|
||||
/* Not using PMECC */
|
||||
if (!(host->nand_chip.ecc.mode == NAND_ECC_HW) || !host->has_pmecc)
|
||||
return 0;
|
||||
|
||||
/* use PMECC, get correction capability, sector size and lookup
|
||||
* table offset.
|
||||
@ -1599,16 +1555,64 @@ static int atmel_of_init_port(struct atmel_nand_host *host,
|
||||
/* Will build a lookup table and initialize the offset later */
|
||||
return 0;
|
||||
}
|
||||
|
||||
if (!offset[0] && !offset[1]) {
|
||||
dev_err(host->dev, "Invalid PMECC lookup table offset\n");
|
||||
return -EINVAL;
|
||||
}
|
||||
|
||||
host->pmecc_lookup_table_offset_512 = offset[0];
|
||||
host->pmecc_lookup_table_offset_1024 = offset[1];
|
||||
|
||||
return 0;
|
||||
}
|
||||
|
||||
static int atmel_of_init_port(struct atmel_nand_host *host,
|
||||
struct device_node *np)
|
||||
{
|
||||
u32 val;
|
||||
struct atmel_nand_data *board = &host->board;
|
||||
enum of_gpio_flags flags = 0;
|
||||
|
||||
host->caps = (struct atmel_nand_caps *)
|
||||
of_device_get_match_data(host->dev);
|
||||
|
||||
if (of_property_read_u32(np, "atmel,nand-addr-offset", &val) == 0) {
|
||||
if (val >= 32) {
|
||||
dev_err(host->dev, "invalid addr-offset %u\n", val);
|
||||
return -EINVAL;
|
||||
}
|
||||
board->ale = val;
|
||||
}
|
||||
|
||||
if (of_property_read_u32(np, "atmel,nand-cmd-offset", &val) == 0) {
|
||||
if (val >= 32) {
|
||||
dev_err(host->dev, "invalid cmd-offset %u\n", val);
|
||||
return -EINVAL;
|
||||
}
|
||||
board->cle = val;
|
||||
}
|
||||
|
||||
board->has_dma = of_property_read_bool(np, "atmel,nand-has-dma");
|
||||
|
||||
board->rdy_pin = of_get_gpio_flags(np, 0, &flags);
|
||||
board->rdy_pin_active_low = (flags == OF_GPIO_ACTIVE_LOW);
|
||||
|
||||
board->enable_pin = of_get_gpio(np, 1);
|
||||
board->det_pin = of_get_gpio(np, 2);
|
||||
|
||||
/* load the nfc driver if there is */
|
||||
of_platform_populate(np, NULL, NULL, host->dev);
|
||||
|
||||
/*
|
||||
* Initialize ECC mode to NAND_ECC_SOFT so that we have a correct value
|
||||
* even if the nand-ecc-mode property is not defined.
|
||||
*/
|
||||
host->nand_chip.ecc.mode = NAND_ECC_SOFT;
|
||||
|
||||
return 0;
|
||||
}
|
||||
|
||||
static int atmel_hw_nand_init_params(struct platform_device *pdev,
|
||||
struct atmel_nand_host *host)
|
||||
{
|
||||
@ -2150,6 +2154,11 @@ static int atmel_nand_probe(struct platform_device *pdev)
|
||||
} else {
|
||||
memcpy(&host->board, dev_get_platdata(&pdev->dev),
|
||||
sizeof(struct atmel_nand_data));
|
||||
nand_chip->ecc.mode = host->board.ecc_mode;
|
||||
|
||||
/* 16-bit bus width */
|
||||
if (host->board.bus_width_16)
|
||||
nand_chip->options |= NAND_BUSWIDTH_16;
|
||||
}
|
||||
|
||||
/* link the private data structures */
|
||||
@ -2191,11 +2200,8 @@ static int atmel_nand_probe(struct platform_device *pdev)
|
||||
nand_chip->cmd_ctrl = atmel_nand_cmd_ctrl;
|
||||
}
|
||||
|
||||
nand_chip->ecc.mode = host->board.ecc_mode;
|
||||
nand_chip->chip_delay = 40; /* 40us command delay time */
|
||||
|
||||
if (host->board.bus_width_16) /* 16-bit bus width */
|
||||
nand_chip->options |= NAND_BUSWIDTH_16;
|
||||
|
||||
nand_chip->read_buf = atmel_read_buf;
|
||||
nand_chip->write_buf = atmel_write_buf;
|
||||
@ -2228,11 +2234,6 @@ static int atmel_nand_probe(struct platform_device *pdev)
|
||||
}
|
||||
}
|
||||
|
||||
if (host->board.on_flash_bbt || on_flash_bbt) {
|
||||
dev_info(&pdev->dev, "Use On Flash BBT\n");
|
||||
nand_chip->bbt_options |= NAND_BBT_USE_FLASH;
|
||||
}
|
||||
|
||||
if (!host->board.has_dma)
|
||||
use_dma = 0;
|
||||
|
||||
@ -2259,6 +2260,18 @@ static int atmel_nand_probe(struct platform_device *pdev)
|
||||
goto err_scan_ident;
|
||||
}
|
||||
|
||||
if (host->board.on_flash_bbt || on_flash_bbt)
|
||||
nand_chip->bbt_options |= NAND_BBT_USE_FLASH;
|
||||
|
||||
if (nand_chip->bbt_options & NAND_BBT_USE_FLASH)
|
||||
dev_info(&pdev->dev, "Use On Flash BBT\n");
|
||||
|
||||
if (IS_ENABLED(CONFIG_OF) && pdev->dev.of_node) {
|
||||
res = atmel_of_init_ecc(host, pdev->dev.of_node);
|
||||
if (res)
|
||||
goto err_hw_ecc;
|
||||
}
|
||||
|
||||
if (nand_chip->ecc.mode == NAND_ECC_HW) {
|
||||
if (host->has_pmecc)
|
||||
res = atmel_pmecc_nand_init_params(pdev, host);
|
||||
|
||||
Loading…
Reference in New Issue
Block a user