hwmon: (ads7871) Fix multi-line comments

Cc: Paul Thomas <pthomas8589@gmail.com>
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
This commit is contained in:
Guenter Roeck 2012-01-19 11:02:15 -08:00 committed by Guenter Roeck
parent d13d6232de
commit 10775d1899

View File

@ -34,9 +34,11 @@
#define REG_SER_CONTROL 24 /*Serial Interface Control Register*/
#define REG_ID 31 /*ID Register*/
/*From figure 17 in the datasheet
* These bits get ORed with the address to form
* the instruction byte */
/*
* From figure 17 in the datasheet
* These bits get ORed with the address to form
* the instruction byte
*/
/*Instruction Bit masks*/
#define INST_MODE_bm (1<<7)
#define INST_READ_bm (1<<6)
@ -105,8 +107,10 @@ static ssize_t show_voltage(struct device *dev,
uint8_t channel, mux_cnv;
channel = attr->index;
/*TODO: add support for conversions
*other than single ended with a gain of 1*/
/*
* TODO: add support for conversions
* other than single ended with a gain of 1
*/
/*MUX_M3_bm forces single ended*/
/*This is also where the gain of the PGA would be set*/
ads7871_write_reg8(spi, REG_GAIN_MUX,
@ -114,8 +118,10 @@ static ssize_t show_voltage(struct device *dev,
ret = ads7871_read_reg8(spi, REG_GAIN_MUX);
mux_cnv = ((ret & MUX_CNV_bm)>>MUX_CNV_bv);
/*on 400MHz arm9 platform the conversion
*is already done when we do this test*/
/*
* on 400MHz arm9 platform the conversion
* is already done when we do this test
*/
while ((i < 2) && mux_cnv) {
i++;
ret = ads7871_read_reg8(spi, REG_GAIN_MUX);
@ -179,8 +185,10 @@ static int __devinit ads7871_probe(struct spi_device *spi)
ret = ads7871_read_reg8(spi, REG_OSC_CONTROL);
dev_dbg(&spi->dev, "REG_OSC_CONTROL write:%x, read:%x\n", val, ret);
/*because there is no other error checking on an SPI bus
we need to make sure we really have a chip*/
/*
* because there is no other error checking on an SPI bus
* we need to make sure we really have a chip
*/
if (val != ret) {
err = -ENODEV;
goto exit;