extcon: fsa9480: Rewrite bindings in YAML and extend

This rewrites the FSA9480 DT bindings using YAML and
extends them with the compatible TI TSU6111.

I chose to name the file fcs,fsa880 since this is the
first switch, later versions are improvements.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>

Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt

@@ -1,21 +0,0 @@
-FAIRCHILD SEMICONDUCTOR FSA9480 MICROUSB SWITCH
-
-The FSA9480 is a USB port accessory detector and switch. The FSA9480 is fully
-controlled using I2C and enables USB data, stereo and mono audio, video,
-microphone, and UART data to use a common connector port.
-
-Required properties:
- - compatible : Must be one of
-   "fcs,fsa9480"
-   "fcs,fsa880"
- - reg : Specifies i2c slave address. Must be 0x25.
- - interrupts : Should contain one entry specifying interrupt signal of
-   interrupt parent to which interrupt pin of the chip is connected.
-
- Example:
-	musb@25 {
-		compatible = "fcs,fsa9480";
-		reg = <0x25>;
-		interrupt-parent = <&gph2>;
-		interrupts = <7 0>;
-	};

Documentation/devicetree/bindings/extcon/fcs,fsa880.yaml

@@ -0,0 +1,52 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/extcon/fcs,fsa880.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Fairchild Semiconductor FSA880, FSA9480 and compatibles
+
+maintainers:
+  - Linus Walleij <linus.walleij@linaro.org>
+
+description:
+  The FSA880 and FSA9480 are USB port accessory detectors and switches.
+  The switch is fully controlled using I2C and enables USB data, stereo
+  and mono audio, video, microphone, and UART data to use a common
+  connector port. Compatible switches exist from other manufacturers.
+
+properties:
+  compatible:
+    enum:
+      - fcs,fsa880
+      - fcs,fsa9480
+      - ti,tsu6111
+
+  reg:
+    maxItems: 1
+    description: The I2C address for an FSA880 compatible device is
+      usually 0x25.
+
+  interrupts:
+    maxItems: 1
+
+required:
+  - compatible
+  - reg
+  - interrupts
+
+additionalProperties: false
+
+examples:
+  - |
+    #include <dt-bindings/interrupt-controller/irq.h>
+    i2c {
+        #address-cells = <1>;
+        #size-cells = <0>;
+        usb-switch@25 {
+            compatible = "fcs,fsa880";
+            reg = <0x25>;
+            interrupt-parent = <&gpio>;
+            interrupts = <1 IRQ_TYPE_EDGE_FALLING>;
+        };
+    };