linux/net/hsr/Makefile

#
# Makefile for HSR
#

obj-$(CONFIG_HSR)	+= hsr.o

hsr-y			:= hsr_main.o hsr_framereg.o hsr_device.o \
			   hsr_netlink.o hsr_slave.o hsr_forward.o
hsr-$(CONFIG_DEBUG_FS) += hsr_prp_debugfs.o
net/hsr: Add support for the High-availability Seamless Redundancy protocol (HSRv0) High-availability Seamless Redundancy ("HSR") provides instant failover redundancy for Ethernet networks. It requires a special network topology where all nodes are connected in a ring (each node having two physical network interfaces). It is suited for applications that demand high availability and very short reaction time. HSR acts on the Ethernet layer, using a registered Ethernet protocol type to send special HSR frames in both directions over the ring. The driver creates virtual network interfaces that can be used just like any ordinary Linux network interface, for IP/TCP/UDP traffic etc. All nodes in the network ring must be HSR capable. This code is a "best effort" to comply with the HSR standard as described in IEC 62439-3:2010 (HSRv0). Signed-off-by: Arvid Brodin <arvid.brodin@xdin.com> Signed-off-by: David S. Miller <davem@davemloft.net> 2013-10-31 04:10:47 +08:00			`#`
			`# Makefile for HSR`
			`#`

			`obj-$(CONFIG_HSR) += hsr.o`

net/hsr: Better frame dispatch This patch removes the separate paths for frames coming from the outside, and frames sent from the HSR device, and instead makes all frames go through hsr_forward_skb() in hsr_forward.c. This greatly improves code readability and also opens up the possibility for future support of the HSR Interlink device that is the basis for HSR RedBoxes and HSR QuadBoxes, as well as VLAN compatibility. Other improvements: * A reduction in the number of times an skb is copied on machines without HAVE_EFFICIENT_UNALIGNED_ACCESS, which improves throughput somewhat. * Headers are now created using the standard eth_header(), and using the standard hard_header_len. * Each HSR slave now gets its own private skb, so slave-specific fields can be correctly set. Signed-off-by: Arvid Brodin <arvid.brodin@alten.se> Signed-off-by: David S. Miller <davem@davemloft.net> 2014-07-05 05:41:03 +08:00			`hsr-y := hsr_main.o hsr_framereg.o hsr_device.o \`
			`hsr_netlink.o hsr_slave.o hsr_forward.o`
net: hsr: add debugfs support for display node list This adds a debugfs interface to allow display the nodes learned by the hsr master. Signed-off-by: Murali Karicheri <m-karicheri2@ti.com> Signed-off-by: David S. Miller <davem@davemloft.net> 2019-04-06 01:31:35 +08:00			`hsr-$(CONFIG_DEBUG_FS) += hsr_prp_debugfs.o`