korg/linux
0
0
Fork 0
mirror of https://mirrors.bfsu.edu.cn/git/linux.git synced 2024-12-15 15:04:27 +08:00
Code Issues Packages Projects Releases Wiki Activity
914535c059
linux/drivers/nvmem/Makefile

31 lines
1.1 KiB
Makefile
Raw Normal View History

nvmem: Add a simple NVMEM framework for nvmem providers This patch adds just providers part of the framework just to enable easy review. Up until now, NVMEM drivers like eeprom were stored in drivers/misc, where they all had to duplicate pretty much the same code to register a sysfs file, allow in-kernel users to access the content of the devices they were driving, etc. This was also a problem as far as other in-kernel users were involved, since the solutions used were pretty much different from on driver to another, there was a rather big abstraction leak. This introduction of this framework aims at solving this. It also introduces DT representation for consumer devices to go get the data they require (MAC Addresses, SoC/Revision ID, part numbers, and so on) from the nvmems. Having regmap interface to this framework would give much better abstraction for nvmems on different buses. Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com> [Maxime Ripard: intial version of eeprom framework] Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Tested-by: Stefan Wahren <stefan.wahren@i2se.com> Tested-by: Philipp Zabel <p.zabel@pengutronix.de> Tested-by: Rajendra Nayak <rnayak@codeaurora.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-07-27 19:13:19 +08:00
#
# Makefile for nvmem drivers.
#
obj-$(CONFIG_NVMEM) += nvmem_core.o
nvmem_core-y := core.o
nvmem: qfprom: Add Qualcomm QFPROM support. This patch adds QFPROM support driver which is used by other drivers like thermal sensor and cpufreq. On MSM parts there are some efuses (called qfprom) these fuses store things like calibration data, speed bins.. etc. Drivers like cpufreq, thermal sensors would read out this data for configuring the driver. Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Reviewed-by: Stephen Boyd <sboyd@codeaurora.org> Tested-by: Philipp Zabel <p.zabel@pengutronix.de> Tested-by: Rajendra Nayak <rnayak@codeaurora.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-07-27 19:15:00 +08:00
# Devices
nvmem: Add the Broadcom OTP controller driver Add support for 32 and 64-bit versions of Broadcom's On-Chip OTP controller. These controllers are used on SoC's such as Cygnus and Stingray. Reviewed-by: Ray Jui <ray.jui@broadcom.com> Tested-by: Jonathan Richardson <jonathan.richardson@broadcom.com> Signed-off-by: Scott Branden <scott.branden@broadcom.com> Signed-off-by: Oza Pawandeep <oza@broadcom.com> Signed-off-by: Jonathan Richardson <jonathan.richardson@broadcom.com> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2016-10-31 22:45:19 +08:00
obj-$(CONFIG_NVMEM_BCM_OCOTP) += nvmem-bcm-ocotp.o
nvmem-bcm-ocotp-y := bcm-ocotp.o
nvmem: imx-ocotp: Add i.MX6 OCOTP driver This driver handles the i.MX On-Chip OTP Controller found in i.MX6Q/D, i.MX6S/DL, i.MX6SL, and i.MX6SX SoCs. Currently it just returns the values stored in the shadow registers. Signed-off-by: Philipp Zabel <p.zabel@pengutronix.de> Acked-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-09-30 20:55:47 +08:00
obj-$(CONFIG_NVMEM_IMX_OCOTP) += nvmem-imx-ocotp.o
nvmem-imx-ocotp-y := imx-ocotp.o
nvmem: NXP LPC18xx EEPROM memory NVMEM driver This commit adds support for NXP LPC18xx EEPROM memory found in NXP LPC185x/3x and LPC435x/3x/2x/1x devices. EEPROM size is 16384 bytes and it can be entirely read and written/erased with 1 word (4 bytes) granularity. The last page (128 bytes) contains the EEPROM initialization data and is not writable. Erase/program time is less than 3ms. The EEPROM device requires a ~1500 kHz clock (min 800 kHz, max 1600 kHz) that is generated dividing the system bus clock by the division factor, contained in the divider register (minus 1 encoded). EEPROM will be kept in Power Down mode except during read/write calls. Signed-off-by: Ariel D'Alessandro <ariel@vanguardiasur.com.ar> Acked-by: Stefan Wahren <stefan.wahren@i2se.com> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-12-07 18:57:39 +08:00
obj-$(CONFIG_NVMEM_LPC18XX_EEPROM) += nvmem_lpc18xx_eeprom.o
nvmem_lpc18xx_eeprom-y := lpc18xx_eeprom.o
nvmem: add NXP LPC18xx OTP driver Add simple read only driver for the internal OTP (One Time Programmable) memory found on all NXP LPC18xx and LPC43xx devices. The OTP memory is split into 4 banks each with 4 32-bits word. Some of the banks contain predefined data while others are for general purpose and user programmable via the OTP API in ROM. Note that writing to the OTP memory is not yet supported. Signed-off-by: Joachim Eastwood <manabian@gmail.com> Tested-by: Vladimir Zapolskiy <vz@mleia.com> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2016-10-31 22:45:16 +08:00
obj-$(CONFIG_NVMEM_LPC18XX_OTP) += nvmem_lpc18xx_otp.o
nvmem_lpc18xx_otp-y := lpc18xx_otp.o
nvmem: add driver for ocotp in i.MX23 and i.MX28 This patch brings read-only support for the On-Chip OTP cells in the i.MX23 and i.MX28 processor. The driver implements the new NVMEM provider API. Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com> Reviewed-by: Marek Vasut <marex@denx.de> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-09-30 20:56:27 +08:00
obj-$(CONFIG_NVMEM_MXS_OCOTP) += nvmem-mxs-ocotp.o
nvmem-mxs-ocotp-y := mxs-ocotp.o
nvmem: mediatek: Add Mediatek EFUSE driver Add Mediatek EFUSE driver to access hardware data like thermal sensor calibration or HDMI impedance. Signed-off-by: Andrew-CT Chen <andrew-ct.chen@mediatek.com> Reviewed-by: Sascha Hauer <s.hauer@pengutronix.de> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-12-07 18:58:11 +08:00
obj-$(CONFIG_MTK_EFUSE) += nvmem_mtk-efuse.o
nvmem_mtk-efuse-y := mtk-efuse.o
nvmem: qfprom: Add Qualcomm QFPROM support. This patch adds QFPROM support driver which is used by other drivers like thermal sensor and cpufreq. On MSM parts there are some efuses (called qfprom) these fuses store things like calibration data, speed bins.. etc. Drivers like cpufreq, thermal sensors would read out this data for configuring the driver. Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Reviewed-by: Stephen Boyd <sboyd@codeaurora.org> Tested-by: Philipp Zabel <p.zabel@pengutronix.de> Tested-by: Rajendra Nayak <rnayak@codeaurora.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-07-27 19:15:00 +08:00
obj-$(CONFIG_QCOM_QFPROM) += nvmem_qfprom.o
nvmem_qfprom-y := qfprom.o
nvmem: Adding bindings for rockchip-efuse There are some SoC specified values store in eFuse, such as the cpu_leakage and cpu_version, this driver can expose these values to /sys base on nvmem. Signed-off-by: Caesar Wang <caesar.wang@rock-chips.com> Signed-off-by: ZhengShunQian <zhengsq@rock-chips.com> Acked-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-09-30 20:56:44 +08:00
obj-$(CONFIG_ROCKCHIP_EFUSE) += nvmem_rockchip_efuse.o
nvmem_rockchip_efuse-y := rockchip-efuse.o
nvmem: sunxi: Move the SID driver to the nvmem framework Now that we have the nvmem framework, we can consolidate the common driver code. Move the driver to the framework, and hopefully, it will fix the sysfs file creation race. Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com> [srinivas.kandagatla: Moved to regmap based EEPROM framework] Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Tested-by: Philipp Zabel <p.zabel@pengutronix.de> Tested-by: Rajendra Nayak <rnayak@codeaurora.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-07-27 19:17:09 +08:00
obj-$(CONFIG_NVMEM_SUNXI_SID) += nvmem_sunxi_sid.o
nvmem_sunxi_sid-y := sunxi_sid.o
nvmem: Add Vybrid OCOTP support The patch adds support for the On Chip One Time Programmable Peripheral (OCOTP) on the Vybrid platform. Signed-off-by: Sanchayan Maity <maitysanchayan@gmail.com> Acked-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-09-30 20:54:59 +08:00
obj-$(CONFIG_NVMEM_VF610_OCOTP) += nvmem-vf610-ocotp.o
nvmem-vf610-ocotp-y := vf610-ocotp.o
nvmem: amlogic: Add Amlogic Meson EFUSE driver Add Amlogic EFUSE driver to access hardware data like ethernet address, serial number or IDs. Acked-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Signed-off-by: Carlo Caione <carlo@endlessm.com> Signed-off-by: Kevin Hilman <khilman@baylibre.com>
2016-08-27 21:43:46 +08:00
obj-$(CONFIG_MESON_EFUSE) += nvmem_meson_efuse.o
nvmem_meson_efuse-y := meson-efuse.o
Reference in New Issue Copy Permalink