mirror of
https://git.kernel.org/pub/scm/network/iproute2/iproute2.git
synced 2024-11-15 14:05:22 +08:00
34 lines
1.2 KiB
Plaintext
34 lines
1.2 KiB
Plaintext
|
|
Here are a few quick points about DECnet support...
|
|
|
|
o iproute2 is the tool of choice for configuring the DECnet support for
|
|
Linux. For many features, it is the only tool which can be used to
|
|
configure them.
|
|
|
|
o No name resolution is available as yet, all addresses must be
|
|
entered numerically.
|
|
|
|
o Remember to set the hardware address of the interface using:
|
|
|
|
ip link set ethX address xx:xx:xx:xx:xx:xx
|
|
(where xx:xx:xx:xx:xx:xx is the MAC address for your DECnet node
|
|
address)
|
|
|
|
if your Ethernet card won't listen to more than one unicast
|
|
mac address at once. If the Linux DECnet stack doesn't talk to
|
|
any other DECnet nodes, then check this with tcpdump and if its
|
|
a problem, change the mac address (but do this _before_ starting
|
|
any other network protocol on the interface)
|
|
|
|
o Whilst you can use ip addr add to add more than one DECnet address to an
|
|
interface, don't expect addresses which are not the same as the
|
|
kernels node address to work properly with 2.4 kernels. This should
|
|
be fine with 2.6 kernels as the routing code has been extensively
|
|
modified and improved.
|
|
|
|
o The DECnet support is currently self contained. It does not depend on
|
|
the libdnet library.
|
|
|
|
Steve Whitehouse <steve@chygwyn.com>
|
|
|