The timeout value has been hardcoded on hci_send_req call and, instead,
it should be passed from above (for ex from hci_le_set_scan_enable).
This patch removes the hardcoded value from hci_send_req and it
increases the timeout to 1000ms.
Set interval and window parameters properly if --discovery option
is present in lescan command.
According to the Bluetooth spec, during a general or limited discovery
procedure the scan interval and the scan window should be set to
11.25 ms. If --discovery option isn't present, both parameters are set
to the default value (10 ms) defined in LE Set Scan Parameters Command.
According to that command description, the interval and window parameters
should be set as follows:
Time = N * 0.625 msec
So, in order to set the time values to 11.25 and 10 ms, the parameters
should be equal to 18 (0x0012) and 16 (0x0010), respectively.
This patch adds the option [--discovery=g|l] to lescan command. Use
this option to enable the general or limited discovery procedure.
If discovery option is not given scanning will display all results
ignoring the AD flags.
Allows the LE master to start the Connection Parameter Update Procedure.
Parameters values consistency are not verified on purpose allowing
invalid values to test fail scenarios.
hciconfig: warrning user on unknown commands
hcitool: return error on unknown command in hcitool
fix length size in comparision to avoid ambiguity commands
check if command number of arguments is correct
This patch lets set_speed function changing UART baud rate to return an
error code if any one operation fails instead of returning only the last
operation's status.
The value 0x03 isn't something that exists in the core spec, so it
shouldn't be used in the same API as SCO/ACL link types. Since there are
some experimental kernel patches that use it this patch makes it private
to hcitool.c.
The Texas specific initialization code sends HCI commands over the
bluetooth socket, but does not bring up the device. This gives these
errors when running "hciattach /dev/ttyUSB0 texas":
Found a Texas Instruments' chip!
Firmware file : /lib/firmware/TIInit_XX.Y.ZZ.bts
Loaded BTS script version 1
Cannot send hci command to socket: Network is down
Can't initialize device: Network is down
This patch implements two new hciconfig commands: leadv and noleadv.
These new hciconfig flags are responsible to LE_SET_ADVERTISE_ENABLE
command implementation.
This patch implements support for the Atheros AR300x Bluetooth chip in
hciattach. It supports configuration download and power management
configure feature.
This provides a new option for hciattach to enable hardware specific
power management from host.
This option by default will be disabled for existing devices
Extend sdptool to allow to add GATT SDP record. Devices that support
GATT over BR/EDR shall publish GATT record. This implementation intend
to be a reference for GATT SDP record creation and it can be a helper
to GATT servers implemented outside BlueZ.
This patch adds a -r switch to hciattach that can be used to initialize
a device into raw mode. This is accomplished with the help of the new
HCIUARTSETFLAGS ioctl.
